Installation Sheet

1Toilet Installation Instructions

Read entire Toilet Installation Instructions.

Observe all local building and safety codes.

TOOLS AND MATERIALS:

BEFORE INSTALLING

INSTALLATION

TOILET

1. Press the new wax ring into place on the toilet ﬂange on the

ﬂoor with the ﬂat side down and the tapered edge up. Apply

enough pressure to hold the ring in place during installation but

be careful not to press it out of shape.

2. Install the anchor bolts through the toilet ﬂange. The anchor

bolts should be pointing upwards so that when the toilet is

placed the bolts will project through the mounting holes on the

base of the toilet.

3. When the wax ring and bolts are attached, lift the toilet and

align the mounting holes with the anchor bolts on the ﬂoor for

proper placement.

Level

INSTRUCTIONS

For the following installation instructions for

your new toilet it is assumed that any old

ﬁxtures have been removed and any repairs to

the water supply and/or toilet ﬂange have been

completed.

Unpack and inspect the product for any shipping

damages. If you ﬁnd damages, do not install.

Contact Customer Service at 1-866-855-2284.

If you need assistance or have questions while

installing your toilet, contact Customer Service.

We recommend consulting a professional if you

are unfamiliar with installing bathroom ﬁxtures.

Signature Hardwareaccepts no liability for any

damage to the ﬂoor, walls, plumbing or for

personal injury during installation.

Shut oﬀ the water supply lines where the new

toilet is being installed.

Latex Caulk

Adjustable Wrench

Hacksaw

Wood Shims

PAGE 1
TOILET BEFORE INSTALLING INSTALLATION Read entire Toilet Installation Instructions. Observe all local building and safety codes. 1. Press the new wax ring into place on the toilet ﬂange on the ﬂoor with the ﬂat side down and the tapered edge up. Apply enough pressure to hold the ring in place during installation but be careful not to press it out of shape.
PAGE 2
INSTALLATION 4. Set the toilet down on the ﬂoor and press in place to form a tight seal with the wax ring. Do not move the toilet after placement, this could break the watertight seal and cause leakage. 5. Thread the washers and nuts onto the anchor bolts. 7. Place bolt caps over the anchor bolts on the base of the toilet. Tip: If the anchor bolts extend too far over the top of the washers and nuts, use a hacksaw to trim to the correct length. 8.
PAGE 3
INSTALLATION 10. Connect the water supply tubes at the bottom of the tank. Turn on the water supply and ﬂush the toilet several times to check for any leaks around the back or base. 11. Attach the toilet seat. 12. Finish your installation by applying latex caulk or tile grout around the base of the toilet. This will ﬁnish the joint between your ﬂoor and toilet bowl and divert water away from the base of the toilet.