Installation Sheet

1
1.800.855.2284
ADD ON SHOWER TUB FILLER
SKU: 329635
REVISED 01/18/2021
CODES: 508430
GETTING STARTED
BEFORE YOU BEGIN
We recommend consulting a professional if you are
unfamiliar with installing plumbing �xtures. Signature
Hardware accepts no liability for any damage to the
faucet, plumbing, sink, counter top, or for personal
injury during installation.
Observe all local plumbing and building codes.
Unpack and inspect the product for shipping damage.
If any damage is found, contact our Customer
Relations team at 1-866-855-2284.
Ensure that you have gathered all the required
materials that are needed for the installation.
For Warranty information, please visit: signaturehardware.com/services/warranty
INSTALLATION
3. Check to make sure the faucet is properly aligned
and adjust as needed. When the faucet is in the proper
position, finish tightening the hex nuts with your
adjustable wrench.
4. Attach the hot and cold water feed tubes to the
water inlets on the back, or bottom of the faucet. (Hot
water is always on the left and cold water is always on
the right)
1. Remove lock nuts from the back or bottom of the
faucet and insert faucet through mounting holes.
2. Hand-tighten washers (if included) and hex nuts to
secure.
5. Finish your installation by attaching any hoses
and/or handles that might be included.
6. After all connections have been made, turn on the
water supply, check to make sure that all connections
are tight (no water should be leaking) and that the hot
and cold supplies are working correctly. Turn the faucet
on and allow the water to flow through the spout for
approximately 60 seconds. If you have a hand shower,
divert the water to the hose and allow the water to flow
through the hose for an additional 60 seconds.
TOOLS AND MATERIALS:
Adjustable
Wrench
Basin
Wrench