Installation Sheet

1Widespread Faucet Installation Instructions

WIDESPREAD FAUCET

INSTALLATION INSTRUCTIONS

Before installing, read entire Widespread Faucet Installation Instructions. Observe all local building and safety codes.

For the following installation instructions for your new Widespread Faucet it is assumed that any old xtures have been

removed and any repairs or modications to the water supply have been completed.

Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer

Service at 1-866-855-2284. If you need assistance or have questions while installing your Widespread Faucet, contact

Customer Service.

We recommend consulting a professional if you are unfamiliar with installing bathroom xtures. Signature Hardware

accepts no liability for any damage to the oor, walls, plumbing or for personal injury during installation.

TOOLS AND MATERIALS:

INSTALLATION

1. If your faucet comes with the brass T attached to the faucet body, unthread and remove the T and associated

hardware.

2. Thread the silver mounting washer and rubber sealing gasket on the faucet body.

3. Apply a bead of silicone sealant to the underside of the spout, or faucet base, and thread through the center

mounting hole.

4. Thread the mounting hardware and brass T onto the spout pipe and hand-tighten to secure.

5. Check to make sure the faucet is properly aligned and adjust as needed. When the faucet is in the proper position,

nish tightening mounting hardware with your adjustable wrench.

Tip: Make sure that the T outlets are aligned at an angle to allow maximum clearance for water connections.

6. Wipe away any excess sealant around the faucet base using your damp cloth.

7. Assemble the handles by screwing the lock nuts down to the end of the handle bodies. If handles are assembled

move on to step 8.

8. Insert the handle bodies up through the mounting holes. Thread the plastic slip washers and rubber sealing gaskets

onto the handle bodies to secure.

9. Hand tighten to attach the hot and cold exible water feed tubes to the handle bodies and brass T. Give a ¼ turn with

pliers or wrench, but don’t over tighten. (Hot water is always on the left and cold water is always on the right.) Curve

tubes as necessary to ensure there are no kinks or knots.

Adjustable Wrench Silicone Sealant Damp Cloth

PAGE 1
WIDESPREAD FAUCET INSTALLATION INSTRUCTIONS Before installing, read entire Widespread Faucet Installation Instructions. Observe all local building and safety codes. For the following installation instructions for your new Widespread Faucet it is assumed that any old fixtures have been removed and any repairs or modifications to the water supply have been completed. Unpack and inspect the product for any shipping damages. If you find damages, do not install. Contact Customer Service at 1-866-855-2284.
PAGE 2
10. Place the handle assemblies on the handle bodies. Make sure that both handles are in the OFF position and tighten the set screw on the top or side of the handle with Allen wrench (provided). 11. Connect the main water supply to the faucet body. 12. To install the new pop-up drain, apply a bead of silicone sealant to the underside of the drain flange and place in the mounting hole. If there is no pop-up drain, move on to step 16. 13.