Installation Sheet

1Ellis-Entrance-Set-Installation Installation Instructions

ELLIS ENTRANCE SET

INSTALLATION INSTRUCTIONS

Before you begin, read the installation instructions below. Observe all local building and safety codes.

Unpack and inspect the product for any shipping damages and ensure that none of the required pieces are missing. If

you nd damages, do not install. Contact Customer Service at 1.866.855.2284. If you need assistance or have questions

while installing your door handle and lock set, contact Customer Service.

We recommend consulting a professional if you are unfamiliar with installing hardware xtures. Signature Hardware

accepts no liability for any damage to the handle, lock set, or door, or for personal injury during installation.

TOOLS AND MATERIALS:

Safety glasses

Tape measure Wood chisel

Drill

Screwdriver

Allen wrench

INSTALLATION

1. If replacing an entrance with the same mounting hole specications, move on to step

2. Hold the template (if included) in place and mark the mounting hole locations on the

front, and side of the door. If no template is provided, use the hardware as a guide to

mark the mounting holes.

3. Drill mounting holes according to the specications on the template.

4. Insert the handle latch bolt (B), and deadbolt latch bold (C) into the side of the door

and adjust as necessary to t your installation.

5. If the latch bolt face plates are not ush with the door, carefully chisel out (mortise)

some of the door as necessary.

6. Drill pilot holes, if necessary and secure the face plates to the side of the door with

the provided mounting hardware.

7. Test t the deadbolt cylinder (E) and interior hardware and exterior hardware to gain a

better understanding of how the pieces t together.

8. With all hardware pieces in place, insert and tighten the long screws from the back of

the door. Hold the interior knob of the deadbolt in place, and tighten the small screw

to secure.

9. Use an Allen wrench to loosen the set screw on the interior knob. Adjust the length of

the spindle for your door, and tighten the set screw.

PAGE 1
ELLIS ENTRANCE SET INSTALLATION INSTRUCTIONS Before you begin, read the installation instructions below. Observe all local building and safety codes. Unpack and inspect the product for any shipping damages and ensure that none of the required pieces are missing. If you find damages, do not install. Contact Customer Service at 1.866.855.2284. If you need assistance or have questions while installing your door handle and lock set, contact Customer Service.
PAGE 2
10. Hold the handle latch bolt in, and insert the spindle through the door. Fit the outside door knob hardware into the latch bolt assembly. Insert the inside door knob hardware, fitting the inside knob over the spindle and aligning the screws holes. Tighten the mounting screws to secure. 11. To install the strike plates (A,D), mark the ends of the latch bolts with lipstick or paint. Close the door, and turn the deadbolt and handle several times to mark the door frame. 12.