Installation Sheet

ManualsBrandsSignature Hardware ManualsKitchen FaucetsSignature Hardware Delilah 1.8 GPM Wall Mounted Bridge Kitchen Faucet

DELILAH WALL MOUNT KITCHEN FAUCET

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

faucet, plumbing, sink, counter top, wall, or for personal

injury during installation.

Observe all local plumbing and building codes.

Unpack and inspect the faucet for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For these instructions, it is assumed that the old

faucet has been completely removed and any

necessary repairs or modiﬁcations to the water

supply have been completed.

TOOLS AND MATERIALS:

Plumbers

Tape

Thread

Sealant

Adjustable

Wrench

Phillips

Screwdriver

1Delilah Wall Mount Kitchen Faucet Installation Instructions

PLANNING

Use the faucet’s PDF speciﬁcation sheet as a refer-

ence when planning your installation. The speciﬁca-

tion sheet can be found and downloaded from the

product page on our website.

Because the faucet speciﬁcation

measurements are approximate and slight

variations may occur, we highly recommend

performing any rough-in procedures with

the faucet on site.

Drill

Pencil

SKU(s): 906111, 906112, 906210, 906211

Summary of content (4 pages)

PAGE 1
SKU(s): 906111, 906112, 906210, 906211 DELILAH WALL MOUNT KITCHEN FAUCET BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, wall, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Thread Sealant Phillips Screwdriver Drill Pencil Observe all local plumbing and building codes.
PAGE 2
DELILAH WALL MOUNT KITCHEN FAUCET Installation 1. Prepare the in-wall plumbing for faucet installation. 1/2” male inlets will need to be installed 8” apart on-center to make the connection to the faucet. 3. Attach the couplers to each of the installed threaded nipples. Apply plumber’s tape or thread sealant to the threads before attaching. Hand tighten, then ﬁnish tightening using an adjustable wrench.
PAGE 3
DELILAH WALL MOUNT KITCHEN FAUCET 5. To attach the handles to the faucet, remove the decorative hot and cold indicators from each handle. Slide the handles onto each stem and tighten the screws to secure using a Phillip’s screwdriver. Once secure, reinsert the hot and cold indicators. IF A SIDE SPRAYER IS INCLUDED WITH YOUR FAUCET, PROCEED TO STEP 6. IF NOT, PROCEED TO STEP 10. 6.
PAGE 4
DELILAH WALL MOUNT KITCHEN FAUCET 9. Determine a location to mount the hand shower cradle on the wall. Remove the cradle from its base by unthreading it. Hold the cradle base up to the wall and mark the location of the mounting hole with a pencil. Set the cradle aside and drill a pilot hole at the marked location. Use the provided screw and anchor to secure the cradle base to the wall, then reattach the cradle to the base. 11. Remove the aerator from the spout and turn the faucet on.