Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom SinksCamille 16" Copper Drop In or Undermount Bathroom Sink

COPPER DROP-IN/UNDERMOUNT SINK

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing bathroom ﬁxtures and plumb-

ing. Signature Hardware accepts no liability for any

damage to the ﬂoor, walls, plumbing, vanity cabinet, sink,

counter top, or personal injury during installation.

Observe all local plumbing and building codes.

Unpack and inspect the sink for damage. If any damage

is found, contact our Customer Relations team at

1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For the following instructions, it is assumed that the

vanity is in place, and the countertop has not yet been

installed.

TOOLS AND MATERIALS:

1Copper Drop-In/Undermount Sink Installation Instructions

Silicone Sealant

(100% Neutral

Cure)

Damp Cloth

Pencil

Summary of content (5 pages)

PAGE 1
COPPER DROP-IN/UNDERMOUNT SINK BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing bathroom ﬁxtures and plumbing. Signature Hardware accepts no liability for any damage to the ﬂoor, walls, plumbing, vanity cabinet, sink, counter top, or personal injury during installation. Observe all local plumbing and building codes. TOOLS AND MATERIALS: Silicone Sealant (100% Neutral Cure) Damp Cloth Pencil Unpack and inspect the sink for damage.
PAGE 2
COPPER DROP-IN/UNDERMOUNT SINK Drop-In Installation 1. Install your counter top onto your vanity cabinet. Refer to the counter top’s installation instructions for guidance. 3. Remove the sink and run a bead of neutral cure silicone sealant around the underside of the rim. 2. Lower the sink into the cutout on the counter to conﬁrm the sink will ﬁt properly. The rim of the sink should sit ﬂat on the counter top. 4. Carefully lower the sink back into the cutout and press the sink ﬁrmly into place.
PAGE 3
COPPER DROP-IN/UNDERMOUNT SINK Undermount Installation 5. Apply a thin bead of silicone sealant around the perimeter of the sink, where the sink meets the counter top. This will prevent moisture from getting underneath the rim of the sink. 1. Carefully turn the counter top over, resting it on a soft, stable surface to prevent damage. 6. Proceed to the installation of your drain and faucet. Allow 24 hours for the silicone sealant to fully dry. 2. Position the sink over its cutout on the counter top.
PAGE 4
COPPER DROP-IN/UNDERMOUNT SINK 3. Use a pencil to draw an outline around the sink perimeter. 5. Carefully place the sink upside down on the counter top, positioning it within your marked outline. Once positioned, press ﬁrmly into place. 4. Remove the sink from the counter top. Apply a bead of silicone sealant around the top edge of the sink rim. 6.
PAGE 5
COPPER DROP-IN/UNDERMOUNT SINK Cleaning and Maintenence 7. Carefully turn the counter top and sink over. If needed, reposition the sink by slightly loosening the wing bolts and adjusting. To protect the copper ﬁnish, it is recommended that a coating of wax is applied to the sink. Most wax products have natural and added UV ﬁlters that help guard against color and ﬁnish degradation. Wax should be applied as often as necessary, depending upon usage.