Installation Sheet

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are



Hardware accepts no liability for any damage to the

faucet, plumbing, sink, counter top, or for personal injury







any damage is found, contact our Customer Relations



Ensure that you have gathered all the required













TOOLS AND MATERIALS:

Adjustable Wrench





Hacksaw



PAGE 1
B AT H R O O M T R I M K I T SKU: 925025 TOOLS AND MATERIALS: BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing �xtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation. Adjustable Wrench Safety Glasses Strap Wrench Observe all local plumbing and building codes. Unpack and inspect the faucet for shipping damage.
PAGE 2
B AT H R O O M T R I M K I T SKU: 925025 OUTLET SUPPLY INSTALLATION 1. Do not use thread sealant on compression threads. Ensure water is shut o� before installation. Clean and deburr pipe before installation. Make sure tube is cut so it is squared and not out of round. Test installation before leaving job site. 2. Place compression nut then brass sleeve on tubing. INLET 3. Insert copper tube into valve and tighten compression nut �rmly using an adjustable wrench. 1.
PAGE 3
B AT H R O O M T R I M K I T SKU: 925025 TRAP INSTALLATION 1. Insert tube into drain outlet and connect with nut and gasket 2. Slide �ange back to wall to cover the drain outlet. 3. Place trap nut and gasket onto tailpiece. Slide trap over tailpiece and tube elbow. Trailpiece must extend 1” to 2” into the trap. Tailpiece may need to be cut to �t. Tighten nuts and gasket. 4. Ensure all connections are tight. Open the drain. Turn on the main water supply.