Electric precision SF-10 OPTICAL FIBER CLEAVER Electric precision SF-10 OPTICAL FIBER CLEAVER 2020/09 U S E R ' S M A N U A L
CATALOGUE Warnings and Precautions 01 Basic Information 02 Appearance 03 Operation instructions 05 Maintenance 12 Common problems and solutions 15
FCC STATEMENT : FCC Radiation Exposure Statement: This device complies with Part 15 of the FCC Rules. Operation is subject to the followingtwo conditions: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should (1) This device may not cause harmful interference, and be installed and operated with minimum distance 20cm between the radiator & your body.
Warnings and Precautions Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER Basic Information Please read this manual carefully before operating the equipment. Follow all safety instructions and Bluetooth for wireless communication warnings contained in this manual. The SF-10 carries out wireless communication through 2.
Appearance Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER 1.Fiber cutting (Manual mode) 2.If the fiber cleaver is not in the normal position, press 1.5 seconds to reset the fiber cleaver Appearance The Bluetooth connection is successful and the indicator light is on Power indicator.
Operation instructions Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER Bare fiber Rubber-covered Wire Tail fiber 1.Peel off the 28-33mm coating and wipe 1.Peel off 33-38mm of the outer plastic skin 1.The outer plastic skin of the tail fiber is the fiber clean with alcohol. 2.Put the clean fiber into the holder base and pay attention to the position of the coating layer.
Operation instructions Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER The default is automatic cutting mode: the fiber with the coating layer removed is placed on the cutter according to the required length, and after closing the upper plate of the fixture, it will be automatically cut without other operations.
Operation instructions Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER Operation instructions 5.Set the cutting length 4.
Operation instructions Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER Maintenance 1.Please clean the glue pad of the holder with a brush before use, and clean the left and right splint. When there are waste fibers or debris on the left and right splints, the fibers cannot 6.View cutting times be clamped or the fibers cannot be cut. 2.
Maintenance Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER Replacement of blade Maintenance Blade clean 1. Turn off the power of the cleaver and remove the blade cover: use first Remove the screw at the position ①② with a screwdriver, and then lift it up Open the lid above the cleaver. 13 2. Change the blade: remove the blade screw ③ with a screwdriver, and Replace with a new blade and click "Next" after the replacement is complete.
Common problems and solutions Electric precision SF-10 Electric precision SF-10 OPTICAL FIBER CLEAVER OPTICAL FIBER CLEAVER The Fiber Cleaver Is Not Cut After Placing The Fiber Clean the left and right splint surfaces and the jig rubber pads The Clamping Surface Of The Fiber Cleaver Cannot Check whether there are broken fibers or residues on the two clamping surfaces of the fiber, Hold The Optical Fiber Or Clip Off The Optical Fiber use a brush to clean it or wipe it with alcohol cotton, and then