Notice: Signal Communications Limited reserves the right to make improvements to the product described in this manual at any time and without notice. This manual is copyrighted. All rights are reserved. This manual may not be copied, reproduced or translated in whole or part without prior consent from Signal Communications Limited: Third party trademarks are the property of their respective holders. Copyright (c) 1995-98 Signal Communications Limited: All rights reserved, Version 2.
FCC Statement on Class B WARNING Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Table of Contents SECTION 1 INTRODUCTION SECTION INSTALLING roofer Pre What You Need System Connections Software Installation Registering the Transmission Unit Connecting Ewing to Shuteye Pre Alarm Port Definition Pin Definitions for Null Modem Cable Transmitter Unit Ee le] SPECIFICATIONS Model: PTA16-B1 and PTA16-C1
SECTION 1 INTRODUCTION Eyelet Pro is an advanced Video Monitoring System. The transmission unit is especially designed for monitoring medium sized firm, factory and warehouse, Two models are available to suit for different applications. PTA16B1 is 2 monitoring system transmitting B/W video frames. PTA16-C1 functions as standard model for the transmission of color video.
SECTION 2 INSTALLING Eyelet Pro What You Need To install and operate the Tattletale Peo transmission unit, the following items are required: o Eyelet Pre Transmission Unit The image transmitter supports up to 16 video sources in all PAL or SCENT format. o CCD Camera Color / monochrome, PAL or SCENT. » Coaxial Cable (GR-59 recommended) It is used to connect the video output of the CCD camera to the video input of Eyelet Pre transmission unit.
System Connections Up to scalars Upton 16 cameras — mg {E44 Compatible Recommended Setup Procedures: Step 1: Plug one end of the Null Modem cable into the socket marked MODEM on the § Step 2: Step 3: Step 4. Step 8: Tale Eye Pre transmitter, then plug the other end to the COM port of the computer.
Software Installation Before setting up Winter, please change the video setting to 800 x 600 ire color or 16-bit high color in Win's Display Properties. Intel software contains an installation program, SEXTUPLET. Please use this program to setup the necessary files into the hard disk of the reception unit, Once you have completed the following installation procedure, you can run Intel directly from your hard disk.
Connecting Winter to Eyelet Pre Ste pl: Make sure you video setting of Win environment is 800 x 600 true color or 800 x 600 16-bit High Co lour. To start Reception Software, click on the Start button on the taskbar, then choose Programs -> Eyelet Pro » Eyelet Pro Rs-AD-1. Step: To connect to the Eyeteeth Pro | click Comet under the Connection menu or the Connect icon.
Transmission Unit The panels of the T8/6Eye Pro transmission unit are shown below : Front Panel Eyelet £27 16 Rear Panel | surrender. | = Omar i Eoe FET bed | idea i Stonemasons Amen Fort.
SECTION SPECIFICATIONS MODEL STANDARD (FP): PARRICIDAL, 625 LINES, 50 FIELDS PER SECOND (Ny: NETSCAPE, 528 LINES, 60 FIELDS PER SECOND INTERFACE 16 CHANNELS, 1.0V,, COMPOSITE, BNC WITH 750 TERMINATION SWITCH RESOLUTION (Hx V} 256% 192 PIXELS GRAY LEVELS 236 COLORS 18 MILLION COMPRESSION SCALE ABLE ADAPTIVE IMAGE COMPRESSION INPUT 16 INDEPENDENT CHANNELS, CHANNEL, DRY CONTACT CONTACT RATING 1 24, 120V AC, RESISTIVITY LOAD: 2A, 28V D.C.