ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 ZIRC-SD3502 Z-Wave & IR Remote Control User’s Manual All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be edited, copied or circulated without prior written agreement by Sigma Designs. © 2012 Sigma Designs, Inc.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 CONTENTS 1. INTRODUCTION ..........................................................................................................................3 2. USAGE ........................................................................................................................................4 2.1 Z-Wave Network Overview .....................................................................................................4 2.2 Initial Inclusion ........
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 1. INTRODUCTION ZiRC is a low cost Remote Control reference design based on the SD3502 for dual-mode, Z-Wave and InfraRed (IR), control of Sigma Designs Internet Television (IPTV) Set Top Boxes (STB). User feedback is through a tricolor LED (red, green, amber) located next to the power button. As a Z-Wave device it can interwork with any other Z-Wave certified device from any vendor. ZiRC can control the STB both in IR mode and in Z-Wave AV mode.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 2. USAGE ZiRC is a low cost Remote Control reference design based on the SD3502 for dual-mode, Z-Wave and InfraRed (IR), control of Sigma Designs Internet Television (IPTV) Set Top Boxes (STB). User feedback is through a tricolor LED (red, green, amber) located next to the power button. As a Z-Wave device it can interwork with any other Z-Wave certified device from any vendor. 2.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 On entering Z-Wave AV mode, the LED will blink green once. In this mode, successful AV commands sent to the STB are indicated by a single green LED blink. While the button is kept depressed, keep alive is sent every 200 milliseconds and the LED will continue to blink green accordingly. Pressing SETUP+PLAY or SETUP+STOP will send a Basic ON or OFF respectively to turn on and off any ZWave equipment that is not AV capable.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 Table 1: Button Mapping Button / IR code Z-Wave AV code ON_OFF 0x0027 FILE_MODE 0x017E SETUP 0x0115 SUSPEND 0x0194 PAGEUP 0x0022 USB_DVDROM_EJECT 0x0091 TV_MODE 0x017C MUTE 0x0001 PAGE_DOWN 0x0023 BT_1 0x0007 BT_2 0x0008 BT_3 0x0009 BT_4 0x000A BT_5 0x000B BT_6 0x000C BT_7 0x000D BT_8 0x000E BT_9 0x000F DELETE 0x007D BT_0 0x0006 CAPS_NUM 0x017B RETURN 0x004B UP 0x001E SOURCE 0x017D LEFT 0x0020 ENTER 0x0024 RIGHT 0x0021 INFO 0x017A DOWN 0x001F HOME 0x00AF MENU
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 REV STOP FWD REPEAT ANGLE PAUSE SLOW TIME_SEEK AUDIO SUBTITLE ZOOM RED GREEN YELLOW BLUE 0x0017 0x0014 0x0016 0x0107 0x003C 0x0015 0x011E 0x017F 0x0041 0x0130 0x0169 0x009D 0x009B 0x009F 0x009A 2.4 Low battery When battery is low, any key press will be immediately followed by 3 red LED blinks. This is an indication to replace batteries. This replaces the normal LED indications described in this document. 2.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 2.8 Send Node Info Some devices set up automatic associations on receiving a Z-Wave Node Information Frame (NIF) from the target device. For this purpose, pressing & holding SETUP+INFO for 3 seconds will cause the LED to blink green once and send out the NIF once. This feature is also a requirement for Z-Wave certification. 2.9 Wake up To conserve power, the ZiRC remains asleep until a key is pressed after which it goes back to sleep after 3 seconds.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 3. FCC NOTICE TO USERS Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 4. EU DECLARATION OF CONFORMITY EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC. The following test methods have been applied in order to prove presumption of conformity with the essential requirements of the R&TTE Directive 1999/5/EC: - - - - EN 60950-1: 2006/A12: 2011 Safety of Information Technology Equipment EN 300 220-1/-2 V2.4.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 Eesti [Estonian] Käesolevaga kinnitab [tootja nimi = name of manufacturer] seadme [seadme tüüp = type of equipment] vastavust direktiivi 1999/5/EÜ põhinõuetele ja nimetatud direktiivist tulenevatele teistele asjakohastele sätetele. English Hereby, [name of manufacturer], declares that this [type of equipment] is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
ZIRC-SD3502 Z-Wave AV / IR Remote Control 1 1 Polski [Polish] Niniejszym [nazwa producenta] oświadcza, że [nazwa wyrobu] jest zgodny z zasadniczymi wymogami oraz pozostałymi stosownymi postanowieniami Dyrektywy 1999/5/EC. Português [Portuguese] [Nome do fabricante] declara que este [tipo de equipamento] está conforme com os requisitos essenciais e outras disposições da Directiva 1999/5/CE.
