SNT User Guide Ref. Rev. 0.1 Date : 12/03/2016 SNT User Guide 0.1 © Copyright SIGFOX Wireless.
SNT User Guide Revision history: Rev. 0.1 I. Date 12/03/2016 Author Ref. Rev. 0.1 Date : 12/03/2016 Change description L.Chagnoleau Preliminary version Introduction................................................................................................................................... 3 II. Requirements ................................................................................................................................ 3 1. Radio considerations ................................
SNT User Guide Ref. Rev. 0.1 Date : 12/03/2016 I. Introduction SNT, for Sigfox Network Tester, is an SIGFOX demonstration transceivers provided exclusively for technology evaluation and network coverage reference measurements. Their primary functionality consists in periodic emission of SIGFOX radio messages meant for reception at any SIGFOX Access Points. Each SNT bears a unique network identity, printed on a package sticker and stored into its memory.
SNT User Guide Ref. Rev. 0.1 Date : 12/03/2016 III. SNT manual operation SNT have two operation mode : standalone mode and serial communication. 1. Standalone mode Pressing the button for a few seconds will activate the device. Then the device will execute the sequence described below. SNT have two mains option : uplink only and bidirectional sequences. These mode can be set by AT commands (see after) By default, this sequence is looped 10 times, and device shuts down automatically.
SNT User Guide 2. Ref. Rev. 0.1 Date : 12/03/2016 Serial AT commands operation AT commands can be sent to the modem by connecting the USB cable to a computer and opening a serial interface. All commands available are listed here: 0.1 © Copyright SIGFOX Wireless.
SNT User Guide Ref. Rev. 0.1 Date : 12/03/2016 IV. WARNING STATEMENTS 1. FCC: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment.
SNT User Guide Ref. Rev. 0.1 Date : 12/03/2016 Cet équipement est conforme aux limites d'exposition aux rayonnements IC établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec un minimum de 15mm de distance entre la source de rayonnement et votre corps. Ce transmetteur ne doit pas être place au même endroit ou utilise simultanément avec un autre transmetteur ou antenne. 0.1 © Copyright SIGFOX Wireless.