Installation Instructions

ManualsBrandsSiffron ManualsElectronicsIntelli SASH

Z504610005

Intelli Anti-Sweep Hook

Insert hooks into pegboard of

desired location without lower

metal lock plate

INSTALL

Allow enough space between the displays

so that product does not touch the surface

below or obstruct other merchandise.

Insert the Lock Down Plate into the holes directly

below the unit. Rotate up into place, until the screw

inserts into back plate.

Tighten screw with a Phillips Head

Screwdriver. Close Screw Cover Cap

when finished.

Lock Down

Summary of content (4 pages)

PAGE 1
Intelli Anti-Sweep Hook INSTALL 1 2 Insert hooks into pegboard of desired location without lower metal lock plate Allow enough space between the displays so that product does not touch the surface below or obstruct other merchandise. Lock Down 3 Insert the Lock Down Plate into the holes directly below the unit. Rotate up into place, until the screw inserts into back plate. 4 Tighten screw with a Phillips Head Screwdriver. Close Screw Cover Cap when finished.
PAGE 2
Intelli Anti-Sweep Hook LOADING MECHANDISE WARNING: Do not overturn coil. Product will go all the way off the rear of the coil and become inaccessible. Insert the merchandise by following the ramp upwards until product stops, then turn the knob 5 counter clockwise until product catches hook.
PAGE 3
INTELLI SASH AND RECEIVER OPERATIONS NOTE: OPERATION GUIDE DOES NOT INCLUDE INITIAL HOOK ACTIVATION/COMMUNICATION INSTRUCTION, WHICH IS NEEDED PRIOR TO LIVE USE. Optional Antenna HOOK OPERATION DISPENSING WILL ACTIVATE AN LED FLASH AND SILENT RF SIGNAL TO THE ECHO BOX ONCE, EVERY TIME THE MERCHANDISE IS DISPENSED. IF THE LED/RF SIGNAL IS TRIGGERED 4 TIMES WITHIN A 10 SECOND PERIOD, THE HOOK WILL SEND A SILENT ALARM (RF SIGNAL) TO THE ECHO BOX, AND FLASH THE LED FOR 5 SECONDS ON THE HOOK.
PAGE 4
Intelli Anti-Sweep Hook FCC Statement TThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.