User's Manual

SIMATIC

Product Information

05/2009

For the operating instructions manual "ET 200pro Interface module IM 154-6 PN HF IWLAN,

Edition 02/2009, A5E01648493-02

This product information contains additional reference notes to approvals according to FCC

and RSS-210 of Industry Canada and is an extension of chapter 10.1 Standards and

approvals. The Product Information is part of the supplied product and the statements made

therein are binding in case of doubt.

Approval according to FCC

This device complies with Part 15 of the FCC Rules

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference, including interference that may cause undesired

operation.

IEEE802.11b or g operation of this product in the USA is firmware-limited to channels 1 through

11.

Notice

Changes or modifications made to this equipment not expressly approved by SIEMENS may

void the FCC authorization to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, wich can be determined by turning

the equipment off and on, the user encouraged to try to correct the interference by one or more

of the following measures:

x Reorient or relocate the receiving antenna.

x Increase the separation between the equipment and receiver.

x Connect the equipment into an outlet on a circuit different from that to wich the receiver

is connected.

PAGE 1
s SIMATIC Product Information . 05/2009 For the operating instructions manual "ET 200pro Interface module IM 154-6 PN HF IWLAN, Edition 02/2009, A5E01648493-02 This product information contains additional reference notes to approvals according to FCC and RSS-210 of Industry Canada and is an extension of chapter 10.1 Standards and approvals. The Product Information is part of the supplied product and the statements made therein are binding in case of doubt.
PAGE 2
Consult the dealer or an experienced radio/TV technician for help. Notice This equipment complies with FCC radiation exposure limits set forth for an uncontrolled enviroment. This equipment should be installed and operated with minimum distance 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.