WIFI module WF-R11M-RWG2 IEEE 802.11b/g/n 1T1R UART SoC Module 特性 Features： 接收制式 Supported WLAN Standard IEEE Std. 802.11b/g/n Wi-Fi 1T1R System-on-Chip UART module 芯片方案 Chip Solution RTL8711AM 结构大小 Size 25.0mm x42.6mm x3.5mm 接口 安装方式 频段 天线 供电电压 UART Plug 2.4G PCB 天线 5V Company Confidential /Country of Origin: 四川爱联科技有限公司 Sichuan AI-Link Technology Co., Ltd.
WF-R11M-RWG2 IEEE 802.11 b/g/n 1T1R UART SoC Module 1. Introduction WF-R11M-RWG2 SoC module designed base on RTL8711AM chip solution, The SOC module is a highly intelligent platform for the Internet of Everything that contains a low-power Wi-Fi connectivity solution on one package. It includes a number of TCP/IP based connectivity protocols along with SSL, enabling a low-cost, low-complexity system to obtain full-featured internet connectivity and reliable information exchange.
WF-R11M-RWG2 IEEE 802.11 b/g/n 1T1R UART SoC Module 1.2. RF Specification Reference SoC RF specification refer to below list. Main Chipset RTL8711AM SoC RF standard IEEE 802.11 b/g/n Operating Frequency 2.412~2.462 GHz/2.422~2.452 GHz UART Interface For testing and OTP programming (Calibration data) Antenna Design Options PCB Antenna/ 1dBi WIFI: 11b: DBPSK, DQPSK and CCK and DSSS 11a/g: BPSK, QPSK, 16QAM, 64QAM and OFDM RF Modulation 11n: BPSK, QPSK, 16QAM, 64QAM and OFDM Data rates 11b: 1, 2, 5.
WF-R11M-RWG2 IEEE 802.11 b/g/n 1T1R UART SoC Module 2. Mechanical Specification 2.1 PCBA Mechanical Outline Drawing Typical Dimension (W x L x T): 25.0mm x42.6mm x3.5mm PCB Thickness: 0.8mm (+/-0.15mm) 2.2 Pin Distribution Definition Pins sequence and distribution list as follows pin num. pin name 1 2 3 4 四川爱联科技有限公司 Sichuan AI-Link Technology Co.,Ltd.
WF-R11M-RWG2 IEEE 802.11 b/g/n 1T1R UART SoC Module FCC Statement FCC regulatory compliance statement §15.19 Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. §15.
WF-R11M-RWG2 IEEE 802.11 b/g/n 1T1R UART SoC Module INTEGRATION INSTRUCTIONS 2.2 This modular transmitter complies with FCC Rules: 47 CFR Part 15, Subpart C 15.247 2.3 Specific operational use conditions Antenna Change Notice to Host manufacturer Recommend using antenna which certified with this module mentioned in this manual.
WF-R11M-RWG2 IEEE 802.11 b/g/n 1T1R UART SoC Module § 15.19 Labelling requirements shall be complied on end user device. Labelling rules for special device, please refer to §2.925, § 15.19 (a)(5) and relevant KDB publications. For E-label, please refer to §2.935. FCC regulatory Compliance Statement mentioned in this manual shall be properly included in host product manual per FCC Rules.
WF-R11M-RWG2 IEEE 802.11 b/g/n 1T1R UART SoC Module This equipment complies with IC RSS‐102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Cet équipement est conforme aux limites d'exposition aux radiations IC CNR‐102 établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé avec une distance minimale de 20cm entre le radiateur et votre corps.
