Standalone Keypad Access Control User Manual Please read the manual carefully before use this unit
1.Packing List Name Keypad User manual Quantity 1 1 Remarks Screw driver 1 Φ20mm×60mm,special for keypad Rubber plug Self tapping screws Star screws 2 2 Φ6mm×30mm,used for fixing Φ4mm×28mm,used for fixing 1 Φ3mm×6mm,used for fixing Please ensure all the above contents are correct.Any missing, please notify the supplier of the unit. 2.
.Description The unit is single door multifunction standalone access controller or a Wiegand output keypad or card reader. It is suitable for mounting either indoor or outdoor in harsh environments. It is housed in a strong, sturdy and vandal proof Zinc Alloy electroplated case which is available in either a bright silver or matt silver finish. The electronics are fully potted so the unit is waterproof and conforms to IP68.
6.Installation Remove the back cover from the keypad using the supplied special screw driver Drill 2 holes on the wall for the self tapping screws and dig a hole for the cable Put the supplied rubber bungs into the two holes Fix the back cover firmly on the wall with 2 self tapping screws Thread the cable through the cable hole Attach the keypad to the back cover. 7.
Pink Pink Doorbell (optional) Green White Yellow Exit button Purple Black Orange Red Blue Magnetic lock
Pink Pink Doorbell (optional) Green White Electric control lock Yellow Black Red Blue Orange Magnetic lock Special power supply Exit button Purple
8.To Reset to Factory Default a. Power off b. Press and hold # key whilst powering on c. On hearing tick twice , release # key, system is back to factory settings now Registered users won’t be deleted when reset to factory default 9.
Change the master code Setting the working mode: Set valid card users only Set valid card and PIN users Set valid card or PIN users 0 New code # New code # The master code can be 6 to 8 digits long 3 0 # Entry is by card only 3 1 # Entry is by card and PIN together 3 2 # Entry is by either card or PIN (default) Add a user in either card or PIN mode, i.e. in the 3 2 # mode. (Default settings) Add a Pin user 1 User ID number # PIN # The ID number is any number between 1 & 2000.
Delete a card user by card. Note users can be deleted continuously without exiting programming mode 2 Read Card # Delete a card user by user ID. This option can be used when a user has lost their card 2 User ID # Delete a card user by card number.
By card Read card By card and PIN Read card then enter PIN # 10.2Door Settings Relay Output Delay Time Set door relay strike time Master code # 4 0~99 # 0-99 is to set the door relay time 0-99 seconds Alarm output time Set the alarm output time (0-3 minutes) Factory default is 1 minute 5 0~3 # Keypad Lockout & Buzzer Actived.
.The unit operates as a Wiegand Output Reader The unit supports a Wiegand 26 bit output, so the Wiegand data wires can be connected to any controller which supports a Wiegand 26 bit input.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.