AD3 Plug-On Transmitter User guide for the AD3 Axient Digital plug-on transmitter. Version: 2.
Shure Incorporated Table of Contents AD3 Plug-On Transmitter WARNING AD3 Axient Digital Plug-On Transmitter Features IR Sync 11 Setting the Frequency Manually 12 Updating Firmware 12 3 3 3 Firmware Versioning 12 4 Updating the Transmitter 12 Included Components 4 RF Mute 13 Optional Accessories 4 Safe Start 13 AD3 Transmitter Overview 4 Input Overload 13 Setup 6 Tone Generator 14 Setting the AA Battery Type 7 Matching Audio Levels with Offset 14 Menu Item Descriptions 15
Shure Incorporated AD3 Plug-On Transmitter WARNING • Battery packs may explode or release toxic materials. Risk of fire or burns. Do not open, crush, modify, disassemble, heat above 140°F (60°C), or incinerate. • Follow instructions from manufacturer • Only use Shure charger to recharge Shure rechargeable batteries • WARNING: Danger of explosion if battery incorrectly replaced. Replace only with same or equivalent type. • Never put batteries in mouth.
Shure Incorporated Features Performance • • • • • • 20 Hz to 20 kHz range with flat frequency response Automatic input staging optimizes gain setting AES 256-bit encryption-enabled for secure transmission >120 dB dynamic range 100 meter (300 feet) line-of-sight operating range Selectable modulation modes optimize performance for spectral efficiency ◦ Standard – optimal coverage, low latency ◦ High density – dramatic increase in max system channel count • Built-in tone generator and RF markers to facilitat
Shure Incorporated View menu screens and settings. Press any control button to activate the backlight. ② Infrared (IR) port Align with the receiver IR port during an IR Sync for automated transmitter tuning and setup. ③ Control buttons Use to navigate through parameter menus and to change settings. ④ Power switch Hold the X button to power the unit on or off. ⑤ Enter button Press to enter menu screens and confirm menu changes.
Shure Incorporated Holds transmitter and microphone securely for hands-free carrying. Setup 1. Slide the tab on the side of the transmitter to open the battery door. 2. Install the batteries. ◦ AA batteries: Place batteries (note polarity markings) and AA adapter as shown below and close the door. ◦ Shure rechargeable battery: Place battery as shown below (note polarity markings). Remove the AA adapter and close the door to secure the battery.
Shure Incorporated Note: If using AA batteries, set the battery type to ensure the transmitter's battery status indicator is accurate. 3. Press and hold X to turn on the transmitter. 4. Select the appropriate input pad or boost to avoid overloading the audio input our add boost to low-output sources: Au dio > Pad ◦ 12 dB: Use with high output sources, such as line levels and point-to-point applications. ◦ Off (default): Use with typical microphones. ◦ +12 dB: Use with low output sources. 5.
Shure Incorporated • Battery Time to Full (only appears when Shure rechargeable battery is being externally charged): Time remaining until bat tery is fully charged • Battery Life: Indicates remaining battery runtime • Charge: Percentage of charge capacity • Health: Percentage of current battery health • Cycle Count: Total of the number of charging cycles for the installed battery • Temperature: Battery temperature reported in Celsius and Fahrenheit Power Over USB When operated with AA batteries, or with
Shure Incorporated Alkaline Batteries Battery Runtime ( hours:minutes) UHF 1.x Battery Indicator 2 mW/10 mW 35 mW 2 mW /10 mW 30 mW 8:00 to 6:00 3:30 to 3:00 5:30 to 4:15 3:45 to 3:00 6:00 to 4:00 3:00 to 2:00 4:15 to 3:00 3:00 to 2:15 4:00 to 1:45 2:00 to 1:30 3:00 to 1:45 2:15 to 2:00 <1:45 <1:30 <1:45 <2:00 <0:45 <0:45 <0:45 <0:45 <0:15 <0:15 <0:15 <0:15 Transmitter Controls Use the controls to navigate menus and update settings.
Shure Incorporated Tip: Hold the ∧ button while powering on to enter safe start mode. Menu Overview Menu Map Tips for Editing Menu Parameters • To access the menu options from the home screen, press O. Use the arrow buttons to see additional menus and parame ters.
Shure Incorporated Battery runtime in hours and minutes or bar display Key: Displayed when encryption is enabled Lock: Displayed when controls are locked. Icon flashes if you attempt to access a locked control (power or menu). STD: Standard Transmission Mode HD: High Density Transmission Mode Locking the Interface Lock transmitter interface controls to prevent accidental or unauthorized changes to parameters. The lock icon appears on the home screen when a lock is enabled. 1.
Shure Incorporated Note: Any change to the encryption status on the receiver (enabling/disabling encryption) requires a sync to send the settings to the transmitter. New encryp tion keys for the transmitter and receiver channel are generated on every IR sync, so to request a new key for a transmitter, perform an IR sync with the de sired receiver channel. Setting the Frequency Manually The transmitter can be manually tuned to a specific group, channel, or frequency. 1.
Shure Incorporated RF Mute RF mute prevents transmission of the audio by suppressing the RF signal while the transmitter remains powered-on. The home screen displays RF Muted in this mode. 1. From the Radio menu, navigate to Output. 2. Choose one of the following options: ◦ On: RF signal is active ◦ Mute: RF signal is disabled 3. Press O to save. Note: Turning the transmitter off and on or replacing the battery will restore Output to On.
Shure Incorporated Input Overload The Tx Overload message appears when the audio input experiences a highlevel signal. The audio LED turns red as an addi tional indicator of an overload. Reduce the input signal or enable the input pad to remove the overload condition. Tip: To enable the input pad, navigate to Audio > Pad and select 12 dB. Tone Generator The transmitter contains an internal tone generator that produces a continuous audio signal.
Shure Incorporated Menu Item Descriptions Radio Menu Freq Press the O button to enable editing of a group (G:) channel (C:) or frequency (MHz). Use the arrow buttons to adjust the values. To edit the frequency, press the O button once to edit the first 3 digits, or twice to edit the second 3 digits. Power Higher RF power settings can extend the range of the transmitter. Note: Higher RF power settings decrease battery runtime. Output Sets the RF output to On or Mute.
Shure Incorporated Selectable polarity assignment for the audio input connector: ◦ Pos: Positive pressure on microphone diaphragm produces positive voltage on pin 2 (with respect to pin 3 of XLR output) and the tip of the TRS output on the receiver. ◦ Neg: Positive pressure on microphone diaphragm produces negative voltage on pin 2 (with respect to pin 3 of XLR output) and the tip of the TRS output on the receiver.
Shure Incorporated ◦ Serial Num: Serial number Reset All Restores all transmitter parameters to factory settings. Specifications Mic Offset Range -12 to 21 dB (in 1 dB steps) Battery Type Shure SB900 series Rechargeable Li-Ion or LR6 AA batteries 1.5 V Battery Runtime @ 10 mW Shure SB900B > 8 hours alkaline > 7 hours Dimensions 126 mm x 44.5 mm x 44.5 mm (5.0in. x 1.8in. x 1.8 in.) H x W x D Weight Without Battery 240 g (8.0 oz.
Shure Incorporated Impedance Pad -12 dB 26.64 kΩ 0 dB 6.64 kΩ Boost 12 dB 6.
Shure Incorporated Frequency Bands and Transmitter RF Power Band Frequency Range (MHz) RF Power (mW)*** G53 470 to 510 2/10/35 G54 479 to 565 2/10/20 G55† 470 to 636* 2/10/35 G56†† 470 to 636 2/10/35 G57 470 to 616* 2/10/35 G62 510 to 530 2/10/35 G63 487 to 636 2/10 H54 520 to 636 2/10/35 K53 606 to 698* 2/10/35 K54△ 606 to 663** 2/10/35 K55 606 to 694 2/10/35 K56◇ 606 to 714 2/10/35 K57△ 606 to 790 2/10/35 K58 622 to 698 2/10/35 L54 630 to 698 2/10/35 P55 6
Shure Incorporated 第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功 能。 第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使 用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機 設備之干擾。 เครื่องโทรคมนาคมและอุปกรณ์นี้มีความสอดคล้องตามมาตรฐานหรือข้อกำหนดทางเทคนิคของ กสทช.
Shure Incorporated K57 606-790 MHz Country Code Frequency Range Code de Pays Gamme de frequences Codice di paese Gamme di frequenza Código de país Gama de frequencias Länder-Kürzel Frequenzbereich A, B, BG, CH, CY, CZ, D, DK, EST, F * FIN, GB, GR, H, HR, I, IRL, IS, L, LT * M, N, NL, P, PL, RO, S, SK, SLO, TR * all other countries * * This equipment may be capable of operating on some frequencies not authorized in your region. See Licensing Information.
Shure Incorporated Note: Please follow your regional recycling scheme for batteries and electronic waste This product meets the Essential Requirements of all relevant European directives and is eligible for CE marking. Hereby, Shure Incorporated declares that the radio equipment is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.shure.
Shure Incorporated L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1. L’appareil ne doit pas produire de brouillage; 2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
