Installation Instructions

ManualsBrandsShunde Advante Electron ManualsElectronicsWireless Door Chime

Receiver unit

Item No.: M-W1901P

The bell push can be mounted on door frame.

The chime can be put on table or put to the

strip.

Installation

Fig. 6

Features:

1. Wireless chime and door/window sensor, for entry

chime/alarm of visitors or intruders.

2. Long remote distance, providing a max.600 ft(200m)

range, depending on actual environment.

3. 32 ring tones for easy choice and 4-level volume control.

4. Door sensor is small size, can be installed or place on

door sash or window sash.

5. Self-learning codes allow users to add more additional

door sensors and chimes.

6. Bell Push uses 1xCR2032 3V Battery(included).

Fig. 4

Fig. 5

USA Plug

Melody Selection

/Pairing Button

Volume control

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications to this unit not expressly approved by the part responsible for

compliance could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition without restriction.

Fig. 2

Magmet

Fig. 1

CR2032 3V battery

Battery cover

2cm

Adhesive Tape

Mount the both pieces

on proper places

Screws

WIRELESS DOOR ALARM SENSOR

Summary of content (1 pages)

PAGE 1
Item No.: M-W1901P WIRELESS DOOR ALARM SENSOR Receiver unit Features: USA Plug 1. Wireless chime and door/window sensor, for entry chime/alarm of visitors or intruders. 2. Long remote distance, providing a max.600 ft(200m) range, depending on actual environment. 3. 32 ring tones for easy choice and 4-level volume control. 4. Door sensor is small size, can be installed or place on door sash or window sash. 5. Self-learning codes allow users to add more additional door sensors and chimes. 6.