User's Manual

Transmitter unit

Receiver unit

Fig. 1

Push button

Use flat screw driver to

push the hole, to open

the cover.

Fig. 3

Fig. 4

Fig. 6

CR2032 3V battery

Adhesive Tape

Screws

LED ON/OFF/

Music Stop

Fig. 2

Replay(Pairing)

Press the button one time in the receiver, to replay the

current sound

Hold the button for 5 seconds,the receiver will have

“Ding-Ding ” ounds.Then press the bell push until the

receiver has “Ding” means pairing between bell push

and receiver is completed.It will have another

“Ding-Ding”

to exit pairing status.



Item No.: X - 581P

The bell push can be mounted on door frame.

The chime can be put on table or put to the

strip.

Installation

To change the battery

Remove the battery cover.

Bell Push uses 1 x CR2032 3V battery

LED Indicator

Sound Selection/

Pairing Button

Shunde Advante Electron LTD.

Wireless Door Chime

Installation Instructions

Fig. 5

AC 120V

Speaker

PAGE 1
Shunde Advante Electron LTD. Wireless Door Chime Installation Instructions Item No.: X - 581P Installation The bell push can be mounted on door frame. The chime can be put on table or put to the strip. To change the battery Receiver unit LED Indicator LED ON/OFF/ Music Stop Remove the battery cover. Bell Push uses 1 x CR2032 3V battery Sound Selection/ Pairing Button Transmitter unit Fig. 4 Push button Speaker Fig. 1 Use flat screw driver to push the hole, to open the cover. AC 120V Fig. 5 Fig.
PAGE 2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.