Installation Notes

Rope lights 3M
Securing clip
Adapter
Controller
Specif ication
A
B
C
D
1
13
1
1
Package contents and specif ication Installation notesTroubleshooting
The controller is connected Rope lights at the other end
2
Controller connection adapter as shown
1
PART DESCRIPTION QUANTITY
ROPE LIGHTS 3M
Instruction Manual
Connect the controller
and tighten the nut
A controller and adapter can connect up to three 3M Rope lights.
If you have been connect more than three,the following problems
may been cause.
If the Rope lights does not light up for a long time in some
modes, you need to press the button and hold for 6 seconds
until the green lights flash three times.
a. The Rope lights behind the third will not light up
b. The brightness of the Rope lights will decrease
c. The Rope Lights will not light up
?
?
If you purchased a 6M Rope lights for connecting, you can use
it as two connected 3M Rope lights.
?
INPUT: 120V ~ 60Hz, 0.64A
OUTPUT: DC24V 1.5A
OPERATION: Indoor/Outdoor
OPERATING TEMPERATURE: -15° F TO 90° F (-26° C TO 32° C)
WARRANTY: One Year Limited
www.ishowtree.com
Scan & See Me!
When you press the Function button, 8 kinds
of modes and themes will come out.
Installation notes
Controller operation and connecting instructions Controller operation and connecting instructions Controller operation and connecting instructions
Connect the power adapter to the power supply
4
Fix the Rope lights to the wall
3
1
2
Tighten
with a tool
Function
Tighten the nut with
clockwise direction
Modes and themes
1
2
3
4
5
6
7
8
Christmas day show 1
OFF
Valentines' day show 1
Independence day show 1
Thanks giving day show 2
St. patrick's day show 2
Halloween show 3
Multi-color show 3
(2-2). Connect 3 sets at most (As shown in figure 2-2):
1
2
3
1
2
3
4
When you purchase 2 sets Rope lights or more, you
can make seamless joint by the following steps:
( 2-1 ). Connection Instruction
1
3 4 5 6
2
Take down the nut with
anti-clockwise direction
A B
C D
Function
If you buy more than three Rope lights and want to connect
together, you need to add more controller and adapter to
achieve this. The connecting operation is shown in the figure
below. Please refer to the APP manual for specific operations.
(As shown in figure2-4):
(2-3). After connection done, press function button
to change the length of the rope lights
a. After connected another Rope lights successfully,
you should press and hold the function button for
3 seconds until it lights up
b. When you want to reset the length of the Rope lights to
one set, you should press and hold the function button for
6 seconds,until the Rope lights flash green lights 3 times.
Note: If other Rope lights have been connected behind, it will
be turn off after reset operation.
Function
Function
(2-4).
2-2 2-4
Function
Please insert the
mistake-proofing
connector in the
correct direction.
Please insert the mistake-proofing
connector in the correct direction.
FCC ID: OXGSL94-3M
Modelÿ SL94-3M