Operating Instructions

COURT SENSOR INSTALLATION OPERATING INSTRUCTIONS

Plug the Ethernet cable from server side to the IN and

Ethernet cable going to next court sensor in the OUT.

Place the court sensor in clear view of the court. Use

the appropriate hardware to attach the court sensor

to the building structure.

Once the court sensor is plugged in and server

is running the court sensor lights should be:

Do not place where people will be standing around, or where

people are walking by. This will disrupt the signal. The court

sensor must only be installed/used indoors, and it must be

installed at a location that maintains a separation distance

greater than 20cm from people in the surrounding area.

SHOTTRACKER.COM

SOLID RED = Bootloading / Initializing

BLINK GREEN = Running (at 5Hz)

PAGE 1
COURT SENSOR INSTALLATION OPERATING INSTRUCTIONS 1 Plug the Ethernet cable from server side to the IN and Ethernet cable going to next court sensor in the OUT. 2 Place the court sensor in clear view of the court. Use the appropriate hardware to attach the court sensor to the building structure. Do not place where people will be standing around, or where people are walking by. This will disrupt the signal.
PAGE 2
COURT SENSOR INSTALLATION NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.