User Manual

Chapter 3. Setting

3.1 Introduction

To view available options for PDT’s setting, tap Start > Settings. Then, there are

three items inside Settings: “Control Panel”, “Network and Dial-up” and “Taskbar

and Start”.

3.2 Control Panel

To view the Control Panel and settings you can modify by tapping Start > Settings >

Control Panel.

Figure 3-1 Control Panel

PAGE 1
Chapter 3. Setting 3.1 Introduction To view available options for PDT’s setting, tap Start > Settings. Then, there are three items inside Settings: “Control Panel”, “Network and Dial-up” and “Taskbar and Start”. 3.2 Control Panel To view the Control Panel and settings you can modify by tapping Start > Settings > Control Panel.
PAGE 2
3.2.1 BarCode Setting CAUTION：Please do not enter into any Barcode Application Program before settings completing this Barcode. There are three Tabs for scanner configuration setting: “Basic” Tab, “Code Configure” Tab and “Code ID” Tab. In addition, there is “BarCode Setup” for the “Code Configure” Tab. 3.2.1.1 “Basic” Tab Figure 3-2 Basic Tab Table 3-1 Basic Explaining Field Name Beep After Scan OK Function Explaining Select the numbers of beep tone after scan OK.
PAGE 3
Field Name Function Explaining Two Times Scan Timeout (sec) Termination Code Continuous Scan Keybd Message After scanning the barcode, give out beep two times. Select the scanning timeout duration (in seconds) from this pull-down list. <2 ~ 10 sec, Default: 5> None After showing barcode, do not action. CRLF After showing the barcode, jump to next row. Space After showing the barcode, jump one unit. Tab After showing the barcode, jump a section. Disable Disable this functionality.