User's Manual
Pantone Black 3 C
Pantone 8001 C
C M Y K
SIZE: 240mm (W) X 195mm (H) X 190mm (D)
Item Barcode # 041226307764
Operation requires 4 “AA” 1.5V alkaline batteries (not included) for car and
one 9V battery (not included) for remote control.
1. Carefully remove items from package.
2. Locate the battery compartment on the back of each item (see diagram below).
3. Swivel latches on bottom of car to release battery pack and insert batteries.
4. Switch both car and remote buttons to “ON” position.
5. For best result use the car on hard surfaces such as wood or tile.
SAFETY PRECAUTIONS
WARNING:
Battery Information and Instructions
Requires 4 x AA (1.5V) size batteries + 1 x 9V battery (Battery not included.)
Always purchase the correct size and grade of battery.
Replace all batteries of a set at the same time.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon zinc), or rechargeable (nickel cadmium) batteries.
Clean the battery contacts and those of the device prior to battery installation.
Ensure the batteries are installed correctly with regard to polarity (+ and -).
Remove batteries from equipment which is not to be used for an extended period of time. Remove used batteries promptly.
RECYCLE YOUR BATTERIES: Battery recycling is recommended.
Find a local recycling center at http://earth911.com/recycling/single-use-batteries/
For ages 6 and up
Please keep packaging for future reference
Colors and decoration may vary
18016S008
Item #60291
$14.99
Quality Guaranteed:
If you are not completely satisfied with this product,
return it for refund or replacement. Comments or questions?
800-697-2448 • www.interamericanproducts.com
Distributed by Inter-American Products,
1240 State Ave., Cincinnati, OH 45202
WARNING!
All rubber bands, plastic headbands, and wire ties,
as well as tags, are not part of this toy and
should be discarded for your child’s safety.
Made in Shantou, China
USES ONE 9V
BATTERY
(NOT INCLUDED)
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Caution: changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures: