User's Manual

VIDEO Doorbell
Quick Install Guide
LED Status
LED Stays Red: Waiting for Wi-Fi setup or Wi-Fi setup failed
LED blinks Red slowly: Start to configure network
LED blinks Blue: Start to connect to network
LED Stays Blue: Wi-Fi setup successfully or Ring Button
pushed by a guest
FRONT Mounting Bracket
Battery Charging, before setup and installation
Charge your device using a USB-compatible charger, to
ensure your device is fully charged. Charge the device
prior to Wi-Fi setup and installation.
Wi-Fi Setup
Before hardware installation, connecting the device to
your home Wi-Fi network (The device Support 2.4GHz Wi-Fi
currently).
And please ensure that your mobile phone is connected to
your home Wi-Fi network before setup.
1. Download and install the Video Doorbell app from App
store or Google play by searching ‘Danale’
2. Launch the ‘Danale’ app and log in with your Danale+
account. If it’s the first time of using Danale+, please sign up
and create your own account.
3. Power on the device by a USB-Compliance charger,
and press the Reset button on the back of the device to
start connecting.
4. Click on Add Device on the app, then search the device
or scan QR Code to finish Wi-Fi setup.
Hardware Installation
1. Remove your current doorbell button and power off your
transformer (for
wired installation only)
2. Install the mounting bracket using the provided
screwdriver bit, handle and drill bit
3. Connect your doorbell wiring to the terminal screws
located on the mounting bracket (For wired installation
only)
4. Place the device on the mounting bracket
5. Tighten the security screws at the bottom of the device
using the proprietary screwdriver bit. Please do not
over-tighten the security screws.
6. Provide power back to your transformer (For wired
installation only)
Additional Installation for electronic chime
If your
chime is electronic, you may need to install a diode,
which is commonly found inside your current doorbell
button, or check with your doorbell manufacturer.
Connect the diode to the terminals with the arrow on the
diode facing towards the doorbell inside chime as show
below
HD Camera
Microphone
Push Button
LED
Speaker
BACK
Doorbell Wire Terminals
Setup Button
Mirco USB Charging Port
Security Hooks
Mounting Hooks
Screw Hole
1
2
3
5
4
6
7
8
9
AC
IN
Rear
Transformer
Front
P1-With Doorbell
Chime(VAC)
Connector
Connector
Secondary Power=
10-36 VAC 10VA
Wired,Mechanical
Doorbell Chime
Low Voltage Transfomer
Primary Power
US=120/130 VAC
UK&EU=220/230/240 VAC
1
X
1
X
1
X
1
X
1
X
4
X
4
X
2
X
2
X
What’s in the box
Mounting Installation
Mounting Bracket
slip into the hooks
120*80-1
05g哑粉纸-彩色印
刷-风琴折
DB3518E-234AA-ZW
234AA
120*80-105g
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.