Product Description

Product description
Packing list
Doorbell indicator light description
Doorbell button operation instructions
Installation Notes
Product instruction manual and
three packs of cards
Infrared light
Switch button
Reset button
AC Power
connector
USB power
interface
The back of the doorbell
Lens
MIC
Photosensitive
PIR
Doorbell button
Work indicator
Front doorbell
Please read the manual carefully before using the product
1
2
3 4 5
Schematic diagram of installing the doorbell AC wiring diagram
Speaker
Speaker
The bottom of the doorbell
Based station
Based station
Dingdong machine
Status Indicator
Cable interface
SD card slot
Reset button
Power connector
Volume/reset
button
Music switch
button
Shockproof sponge pad×1
Video doorbell×1
Set 1: Video doorbell + Ding Dong
AC Power extension cord×2
Synopsis×1 Disassemble the needle×1
Screw pack×1Dingdong machine×1
Angle bracket (optional)
speaker
1 2 3
3
Power cord×1
Shockproof sponge pad×1
Video doorbell×1
Set 2: Video doorbell + Base station
AC Power extension cord×2
Synopsis×1 Disassemble the needle×1
Screw pack×1Base station×1
Angle bracket (optional)
Power cord×1
Shockproof sponge pad×1
Video doorbell×1
Set 2: Video doorbell + Base station + Ding Dong
AC Power extension cord×2
Synopsis×1
Disassemble the needle×1
Screw pack×1
Base station×1
Angle bracket (optional)
Dingdong machine×1
Power cord×1
1. The device is powered on, and the device is waiting for network
distribution. －The blue ring light flashes slowly.
2、The device fails to connect to the network－the blue ring light
flashes quickly.
3. The equipment is successfully distributed to the network－the blue
ring light is on.
4、The device is in normal standby mode－the blue ring light is always off.
5. The device wakes up－blue circular breathing light.
6. The doorbell is pressed－blue circular breathing light.
7. The blue ring light flashes slowly during the OTA upgrade of the device.
8. The device is charging－the green ring light is always on.
9. The device is fully charged－the green ring light goes out.
10. The device is charging abnormally－the green ring light flashes quickly.
11. The equipment is abnormal－the blue ring light is always on (always on).
Power on: Long press the switch button and the doorbell button at the
same time for 2 seconds to turn on the device.
Shut down: Press and hold the switch button + doorbell button for 5
seconds, the device will shut down.
Reset : Long press the reset button for 5 seconds.
Wall anchor×3 Mounting screw×3 Terminal screw×3
1. Drive the wall anchor into the wall according to the positioning;
2. Fix the back plate to the wall anchor with mounting screws;
3. Put the doorbell down on the back panel.
Terminal screws : After connecting the wires to the terminals on the back
of the smart doorbell, tighten the two terminal screws.
Mounting screws : Use two to mount the bracket on the wall, and the
other for spare.
Wall Anchor :When installing on concrete, plaster or brick, you can
choose to push two anchors into your wall to drill;
In the hole, the other is used for spare.
Low Power Intelligent AC Video Doorbell