Installation Instructions

PLEASE READ THIS MANUAL CAREFULLY AND KEEP IT FOR FUTURE REFERENCE

1. Install on brick or concrete wall,

Hammer the plastic plugs into the holes.

Using screw driver to drive firmly.

mark the installing position,

2. Install on wooden wall, using the same way as above but no need to use plastic plugs.

3. Adjust the joint bolt to fix the solar panel direction.

1. Insert the stake firmly

2. Plug in the ground

S14 PATIO SOLAR STRING LIGHTS

CLIP ON DECK

180

。

180

。

using electric drill to drill three

holes.

PAGE 1
. Install on brick or concrete wall, mark the installing position, using electric drill to drill three holes. Hammer the plastic plugs into the holes. Using screw driver to drive firmly. S14 PATIO SOLAR STRING LIGHTS 2. Install on wooden wall, using the same way as above but no need to use plastic plugs. 3. Adjust the joint bolt to fix the solar panel direction. 。 180 1. Insert the stake firmly 2.
PAGE 2
1. Connect the string lights with solar panel and hang up with cable ties. Indicator Step 1: Screw out the old one from the holder counterclockwise. Step 2: Screw up a new one properly clockwise. Step 3: Complete. E26 base 2. Press the button on the back of panel to switch on, the indicator will turn blue. The string light will be on at dusk and will be off at dawn automatically. 3. Use the button on remote to set timer(the lights will flash once when timer set), brightness, speed or modes. 1.
PAGE 3
FCC statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC warning: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.