Installation Instructions

Product Parameter：

Size ：66ft

Power Cord：9.8ft

Product Power：6W

Working Temperature : -10℃-50℃

Material : PS / PVC

IP Rank : IP44

Application : Application : Indoor / Outdoor

Installation Instructions :

1 ) Open the package and take out the light . Check every componentbefore installation , and

check if the power supply meets the standardof working voltage .

2 ) Product belt hanger , can not be cut to use .

Schematic Diagram:

The characteristics of the power is receiving can be achieved 360 degreeswithout dead Angle ,

which can be controlled through the obstacles , thedistance can reach 20 meters . In open areas ,

the distance can reach further .

This power supply has a memory function . When the power is restored after apower failure , it

will restore the previous state ( including the timer switch anddimming brightness state ) , but

when the remote control is turned off andturned on again , the timer function will be cancelled ,

and the brightness andmode of the light will remain the previous state.

PAGE 1
Product Parameter： Size ：66ft Power Cord：9.8ft Product Power：6W Working Temperature : -10℃-50℃ Material : PS / PVC IP Rank : IP44 Application : Application : Indoor / Outdoor Installation Instructions : 1 ) Open the package and take out the light . Check every componentbefore installation , and check if the power supply meets the standardof working voltage . 2 ) Product belt hanger , can not be cut to use .
PAGE 2
MODE1 . Combination 2 . Led1 steady on 3 . Led2 steady on 4 . Led1 Slo-glo 5 . Led2 Slo-glo 6 . Led 1 & Led2 sequential 7 . Led1 & Led2 twinkle 8 . Led1 & Led2 slow fade 9 . Slo-glo Note : When the remote control distance is greatly reduced , the battery may not be enough . Pleasereplace the new battery as shown on the back of the remote control . Battery type : CR2025 Safety Instructions: 1 ) The string light cannot connect to the socket directly , it must use the power adapter provided by the supplier.
PAGE 3
party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.