Installation Instructions

Car wireless charger

This device complies

with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may

cause undesired operation.

Note: This equipment

has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following

measures:

—Reorient or

relocate the receiving antenna.

—Increase the

separation between the equipment and receiver.

—Connect the

equipment into an outlet on a circuit different from that to which the receiver

is connected.

—Consult the dealer

or an experienced radio/TV technician for help.

Wireless Charging Zone

Automatic switch clamp

Indicator light

Magnetic plug

Infrared Sensing Zone

Touch Switch (Back)

PAGE 1
Car wireless charger Touch Switch (Back) Wireless Charging Zone Automatic switch clamp This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
Instruction: The car wireless magnetic charger is not only suitable for all mobile phones that pass the QI wireless charging protocol, but also for mobile phones that do not have wireless charging function. Mobile phones without wireless charging only need to be plugged in the corresponding magnetic plug. It is also convenient to use mobile phone bracket, automatic induction switch and automatic charging with one-handed operation, so it makes a better trip.
PAGE 3
Note : 4. Place mobile phones that need to be recharged. 5. Touch the top back sensing area when removing 3/4 1. This product should be used as required, otherwise it may cause fire, explosion or other danger. 2. Please use the QC3.0 or PD fast charger, otherwise, it may not be able to turn on or off automatically ,or not charge or charge slowly. 3. Please use the original data cable. This device has a large input current and needs to support charging cables for more than 2A.
PAGE 4
12V1.5A Output: 15W 10W 7.