Installation Instructions

FCC Warning
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:(1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.Any Changes or modifications not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment. This equipment has been
tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure
requirement.
FCC RF exposure statement:
The equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. During the operation of
device a distance of 15 cm surrounding the device and 20 cm
above the top surface of the device must be respected.