USER MANUAL SOLAR LANDSCAPE LIGHT Water Proof Heat Resistance Frost Resistance 30 LED
INTRODUCTION The solar Landscape light can automatically detect surrounding brightness: it enters charging mode to convert sunlight to electricity that is stored in the built-in battery in daytime; it automatically lights up at night. It has 10 modes, and you can adjust to a desired mode by pressing the back button of the product or by remote control. Low-power indicatorrol PACKING LIST ON/OFF WHITE WARM BRIGHT MODE 6 1.Solar Landscape Light 2.Extension stick 3.Ground Stake 4.Screwvv 7 5.
OPERATION GUIDE 1.The default mode of the product is OFF mode. When using it for the first time, you must short press the back button of the product to turn on the product before using the remote control! THE OPERATION METHOD OF PRODUCT BACK BUTTON Mode 1: Low Light Short press the power button for once, the landscape light will enter a low white light mode.It will charge but not light up in the day, and it will automatically light up dim white light in darkness or at night.
Under medium white light mode, short press the back button of the product again. The landscape light will enter a medium warm light mode. It will charge but not light up in the day, and it will automatically light up medium warm light in darkness or at night. Mode 4: High Light Low-power Indicator : When the low-power indicator flashes red, it indicates that the battery is in low-power state.light.
NOTE: INSTALLATION 1. It is recommended to turn off the light and charge it under direct sunlight for 1-2 days before the first use. Make sure the product has enough power. Press the back button and select a desired mode. Then choose a place that can get enough sunshine to install the light, the longer it gets sunshine, the longer it can illuminate. 2.
FAQ Method 2: Wall Mounted Punch two holes on the wall with a drill and insert the attached wall plugs into the holes. Then, twist the screws through the screw holes of holder into the wall plugs. Adjust the angle, then tighten the holder and the light through the knob screw. Wall plugs 40mm Screws Holder 1. My light doesn’t work after being used a few days or months.
3 Check whether the solar panel is covered with dusts and clean it regularly. 4 The lighting time in winter is shorter than that in summer, because the solar light intensity is weaker and charging time is shorter in winter. 4. The light is waterproof. What causes it waterproof failure? When installing or using, if the product falls from a high place, it may cause waterproof failure. It’s subject to high-intensity storms continuously.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. THANKS FOR READING! If you have any questions about our product, be free to contact us. This device complies with part 15 of the FCC Rules.