User's Manual

Wireless Smart Door Sensor

Functions/Features:

Mainly detect open/close states of doors and windows, generally set as a 1

Defense Line or perimeters.

If any doors or windows are opened, it will transmit the alarm signal to notify the alarm host.

Automatically detect the open/close of the doors and windows and send state signal to the host.

Specifications:

 Operating power: 23A 12V Battery (Recommended: alkaline battery)

 Wireless transmitting: distance: ≥450ft (in open area

 Service life: ≤2 years

 Alarm distance:

＜

4cm.

Installation and Usage:

Mount the magnet or smaller piece onto the door in a position of about 5~6ft above the ground to prevent any

child(ren) to pampering. Use the included mounting bracket if the door and the door frame are un-even or not flush.

Mount the emitting or larger piece onto the door frame, ensure the magnet piece and the emitting piece are even or

flush.

The spaces between the two should be less than 10mm in gap.

Replace the batteries if the blue LED light flashes frequently.

Adding and Cancelling Smart Door/Window Sensor

A. Add

Press _Set + Password + ENT _ then.

_70 + ENT + XX + ENT -------The “Learn” light will appear solid red.

Note: The XX indicates group number of the defense zones, including zone 06 through 10.

Press the smart door/window sensor twice consecutively, if you hear “Di----” form the alarm host and

see the “Learn” light flashes five times and off, it indicates successfully added.

B. To Cancel:

Press _Set + Password + ENT _ then.

_71 + ENT + XX + ENT -------The alarm host will beep twice then the “Learn” light will flash once and

then turns off to indicate the doorbell button has been successfully cancelled.

Note: The alarm host can only learn 1 wireless device (Wireless S

mart Door/Window Sensor

) at one

time, a total of 4 wireless Devices (Wireless S

mart Door/Window Sensors

) to a zone/group can be

PAGE 1
Wireless Smart Door Sensor Functions/Features: st Mainly detect open/close states of doors and windows, generally set as a 1 Defense Line or perimeters. If any doors or windows are opened, it will transmit the alarm signal to notify the alarm host. Automatically detect the open/close of the doors and windows and send state signal to the host.
PAGE 2
added. For example, if 4 sensors were to be added to zone/group 01 through zone/group 15, it total 60 sensors in all. If 1 device is removed from a group that has 4 devices, then all 4 devices in the group will be automatically removed, and each device(s) will have to be added again to the alarm host. Enabling and Activating Smart Zone Function Press _Set + Password + ENT _ then.