User's Manual

Table Of Contents

Firefly Laser Projector

User Manual

Thank you for your purchase. Plese read this manual carefully

before operation. It will give you general information

for your safety and optimal performance.

What’s in the box

1.Laser light x 1 2.Adaptor x 1

3.Power cord x 1 4.Bracket x 1

5.Ground stake x 1 6.Remote control x 1

7.Screws x 1 8.User Manual x 1

9.Base x 1

Safety Attention

-Allowing the unit to cool for 30 minutes after 6 hours of

operation will increase the life of the light source

-This is a Class II laser light.

-This product can be used either outdoors or indoors. It is

waterproof(Ip65).Do not put this near flammable objects

or liquids. Do not stare into the light source

Please only use the power adapter that is included. If an

extension cord is needed, please check that the extension

cord s manufactured to the specifications needed for

the environment and application that it is being used for.

2) Mounting and Positioning:Mount the laser and adjust the

angle of the laser light to you needs:The laser light should be

Installation

1) Cable and Plug Adapter: Connect the cable to the plug

adapter. Make sure that the 2pin plug is oriented in the

right way. The Flat and Keyway need to match

otherwise there will be no contact. Screw the connct

or cap securely.

fixed to a solid object, by inserting it into soil, attaching

it to trees,or by placing it on the floor or ground. It is

essential to beattached securely for a safe installation.

Do not stare into the beam. Be sure that there are no

flammables or explosives nearby.

3)Power adapter: The power adapter should be installed indoors

or to a proper outdoor, waterproof outlet.

4)Remote Control: Pull the plastic sheet out of the bottom of the

remote before use.(This can be put back in to conserve battery

life when the remote is not used for extended periods of time.)

PAGE 1
Firefly Laser Projector User Manual What’s in the box 1.Laser light x 1 3.Power cord x 1 5.Ground stake x 1 7.Screws x 1 9.Base x 1 2.Adaptor x 1 4.Bracket x 1 6.Remote control x 1 8.User Manual x 1 1) Cable and Plug Adapter: Connect the cable to the plug adapter. Make sure that the 2pin plug is oriented in the right way. The Flat and Keyway need to match otherwise there will be no contact. Screw the connct or cap securely.
PAGE 2
Assebly Steps Remote Control Instructions 4. 5. switch between Auto Color-changing mode/Maual mode There are three options: Slow, Fast and Static 6. If you need to use the timer, press the .The light will strobe two times to show it has accepted the command. Then press the corresponding time you want to set the timer. Power on/off Firefly Automatically If you want to cancel the timer, press the .The light will strobe twice to show it has accepted the command. Flash Eg: Set the timer for2 hours.
PAGE 3
FCC Caution § 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.