EC4 DASH CAM CAR DIGITAL VIDEO RECORDER User’s Manual
1. Operation Conditions • Read the terms of the warranty service. • Do not insert or remove a memory card while the DVR is turned on. It may cause damage to the device, memory card and recorded video files. • Use only high-quality microSD cards of at least class 10 providing for the UHS-I protocol to avoid recording failures and playback delays. • It is recommended to use 8 GB to 64 GB memory cards. • The device should only be used with the accessories supplied.
• Do not manipulate the device while driving to be sure you are driving safe. Please, observe the local law. • Set the correct date and time before using the device. • Heating of the case during operation is normal. • Handle the device with due care; avoid dropping/crushing the device. The manufacturer reserves the right to change the equipment list, hardware and software of the device without prior notice. It is assumed that you agree with the provisions above before you start using the system.
1. Specifications: • Video resolution: FHD 1440P • Without screen • Built-in battery • Video recording format: MP4 • Built-in microphone / speaker • G-sensor • Parking mode • Loop recording: 1/3/5 min • Continuous recording • Auto Power On • Date / time stamp • 8GB to 128GB MicroSD (Class 10) • Storage temperature: -20˚ to + 70˚ • Operating temperature: -10˚ to + 60˚ • Input voltage: 5VDC, 1.
2. Equipment: • Car digital video recorder (DVR) • Magnet holder • Car charger • User manual • Trim removal tool 3. Description of the device and its buttons Button description Button ON / OFF Description Press to turn the device on. Press and hold to turn the device off.
4. Installing the DVR Installation on the windshield - Choose the installation location in advance, as the adhesive tape on the mount is of single use. - Degrease the mounting location and warm it up to ensure strong adhesion. - Install the magnet holder into the device and turn the DVR on. When evaluating the display image, make sure that the horizontal is kept and the lens captures the image symmetrically both on the left and right.
5. Device operation Device preparation A. Insert the microSD card into the memory card slot. Before installing a memory card, turn off the device; insert the memory card until it is locked. ATTENTION: Attempting to insert a memory card wrong may damage the device and/or the memory card itself. Make sure the memory card is in the correct position. Warning: Do not apply excessive force when inserting a memory card to avoid damage to the device.
Loop recording 1) Insert the microSD card into the memory card slot; the Loop Recording mode turns on automatically. 2) It is recommended to set a 3-minute cycle (Settings). 3) When there is no more space left on the memory card, the device will automatically replaces the oldest video file with the newest one; exception is the files protected from deletion. 4) Video recordings taken in Loop Recording mode are stored in the Video folder.
8) Format the memory card with the DVR menu. ATTENTION! If the memory card is not formatted after the update, the update process will be started again the next time it is turned on. ATTENTION! Do not turn off the DVR power during the firmware update. 7. Possible problems and their causes This section helps you to eliminate problems the device may have under normal operation. - Failure to photograph/record video. Check if there is enough free space on the microSD card and if it is not blocked.
FCC Warnning: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.