User Guide Motorcycle 4-Way Conference Intercom
Table of Contents Introduction ---------------------------------------------- Page 1 Packet Contents ----------------------------------------Page 2 Install Instructions ---------------------------------------Page 3 Charging ---------------------------------------------------Page 5 General Operation Instructions -----------------------Page 5 FM Operation ---------------------------------------------Page 8 Universal Pairing and Using ----------------------------Page 9 Bluetooth Intercom Talk -----------------
Introduction Thank you for choosing the T30-S Motorcycle 4 Riders full-duplex stereo Bluetooth wireless helmet headsets, designed for installing into most open-face, flip-front and full-face style helmets. With the T30-S, you can call hands-free on your Bluetooth mobile phone, listen to music or voice instructions of GPS navigation, and activate wireless intercom for rider to rider or rider to passenger intercom talk within range of 2100 meters(Depending on terrain conditions).
2: Packet Content 2
HIFI Speaker and Microphone Type C USB Cable Clip Mounting Bracket User Guide 3: Install Instructions 1:Locate the helmet at the left and clean it up 2:Peel off the 3M rubber protective film 3:Apply pressure to the metal carrier to secure the holder firmly Note: it takes 24 hours after drying.
Install host 1:Slide T30-S host off the top of the clip and you'll hear a click when it is completely plugged in 2:Plug in the Type C headset plug Headset mounting method 1:Stick the left and right horns of the headphones in the position of the left and right ears of the helmet 2: Keep the microphone in front of the mouth,Note: microphone holes point to the mouth 4
4: Charging 1. You can charge with the Type C USB cable in the package. During charging, red light is on, after full charging, the light will turn blue. It is recommended to recharge the battery before each use. Suggest full charge before each use. 2. Low battery warning:Headset will automatically voice prompt low battery at every 5 minutes to prompt the user to recharge it. 3. Battery state notify: When standby, long press Volume- button 1s to report battery level.
Answer phone calling: The unit will automatically answer the incoming call after 12 seconds. Or press Phone button to answer the incoming phone call immediately.
phone conversation. When finish the second cell phone conversation, will back to the conversation with fist cell phone. Reject third party calls: When connecting two cell phones, during phone call with first cell phone and second cell phone dial in, can short press button Intercom to reject the second cell phone. Music Control: Press the Phone button to play and pause the music. When playing music, double press Volume + button to go to next track, double press Volume - button to go to previous track.
6: FM RADIO Turn on/off radio When in standby mode, press and hold button Phone 1 seconds to turn on FM radio. Press and hold it again for 1 seconds to turn off FM radio. FM Radio Station Search While in FM mode, double press Volume + button or Volume - button two times to search a next/previous FM channel. Preset and store up to 6 FM radio stations In FM radio mode, when a favorite station is found, double press Phone button to save, a beep tone will sound. Preset and store up 6 FM radio stations.
7: Universal Pairing and Using Power on other brand Bluetooth device into pairing suitable, meanwhile T30-S at standby mode, press and hold button Intercom for 1 seconds, red and blue light flashing, then press button Intercom ,the blue light flashing. After pair successful, the blue light slows down. After paired, while T30-S at standby mode, press Volume+ and Volume- button at the same times, T30-S reconnect with Bluetooth headset which connected before and start talking.
8: Bluetooth Intercom Talk The T30-S can be paired with other T30-S for up to a total of 4 units for full duplex Bluetooth intercom. Pairing Two T30-S headsets and talk Step 1: Power on unit 1 and unit 2, press and hold unit 1 and unit 2 Intercom Button and blue light light flash alternately, for 1s, red then press Intercom button on either unit, the blue light flashing. After pair successful, the blue light slows down.
Pairing Three T30-S headsets and talk Step 1: Power on unit 1 and unit 2, press and hold unit 1 and unit 2 Intercom Button and blue light light flash alternately, for 1s, red then press Intercom button on either unit, the blue light flashing. After pair successful, the blue light slows down.
Step 4: After pair finished, double press Intercom button on unit2 or unit3, it will start intercom between unit2 and unit3. During Intercom talking, short press Intercom button or Phone button to exit intercom mode. Pairing Four T30-S headsets and talk Step 1: Power on unit 1 and unit 2, press and hold unit 1 and unit 2 Intercom Button and blue light light flash alternately, for 1s, red then press Intercom button on either unit, the blue light flashing.
Step 3: Power on unit 3 and unit 4, press and hold unit 3 and unit 4 Intercom Button and blue light light flash alternately, for 1s, red then press Intercom button on either unit, the blue light flashing. After pair successful, the blue light slows down. Step 4: After pair finished, Short press Intercom button on unit1 or unit2, it will start intercom between unit1 and unit2. Step 5: After pair finished, double press Intercom button on unit2 or unit3, it will start intercom between unit2 and unit3.
9: Technical specifications: 1. Bluetooth 4.2 Support : HSP,HFP,A2DP,AVRCP, AGHSP 2. Working hours: 15 hours 3. Standby time: 300 hours 4. Charging time: 3 hours 5. Battery: lithium containing rechargeable lithium battery 650mAH, 3.7v 6. Dimensions: 7. Weight: 43g 85mm*40mm*26mm 8. Certification :CE, FCC, TELEC NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
- Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
MADE IN CHINA Web: www.winnerelec.com E-mail: sales@winnerelec.