User's Manual

60.0 mm
90.0 mm
Qone说明书
正面
反面
Outdoor Wireless Speaker
Only charge with devices rated and marked with 5V to avoid damage to the speaker.
Do not open up the speaker, it voids the warranty and may damage the product.
Rechargeable baeries have a limited number of charge cycles. Baery life and number of charge cycles
varies by use and sengs.
Never place the speaker close to high temperature heat sources.
To keep the warranty valid, never try to repair the product yourself.
SAFETY INSTRUCTIONS
Read all instrucons
1.
2.
4. 5.
6.
7. 8.
1. Lanyard.
2. Power buon: power on/off, switch the playing mode, reset.
3. Pause buon: play, pause, answer call, TWS.
4. -: Volume down buon: previous song, decrease the volume.
5. +: Volume up buon: next song, increase the volume.
6. TF card slot.
7. USB charging port.
8. LED indicator.
9. Bluetooth indicator.
10. Microphone.
PARTSAND FUNCTIONS
CHARGING
Connect the supplied charging cable to the charge input and to a USB port on your computer or a USB
charger. The charging LED is lit red during charging. The LED turns off when fully charged.It is recommended
to charge 10 minutes before power on if you 7 days unused, then you can connue to use while charging.
THE SPEAKER’S BATTERY
A built-in rechargeable baery powers the speaker.
POWER ON/OFF
Power on: Long press power buon 3 seconds to power on the speaker, then the Bluetooth indicator light is
on and you can connect Bluetooth devices.
Power off: Long press power buon 3 seconds to power off the speaker, and then Bluetooth indicator
will turn off.
CONNECT THE SPEAKER
DISCONNECT THE SPEAKER
When it’s connected via Bluetooth: double click power buon to disconnect.
RECONNECT THE SPEAKER
Some Bluetooth devices support automac reconnecon, with those devices the speaker will automacally
reconnect.
The speaker will not automacally reconnect on devices that does not support automac reconnecon.
When it’s not connected: double click power buon to connect to the last disconnected device.
PLAYING MODE
Short press power buon to switch different playing mode: BT, TF.
WATER
RESISTANT
T
RATING
IPX4
尺寸: 90mm X 60mm ( 折好后尺寸） - 360mm X 60mm ( 展开尺寸 )
工艺说明: 单色正反面印刷， 105g 铜板纸.
1. Connect your phone via Bluetooth, the speaker will play ringtones while a call coming.
2. Short press the pause buon to answer the call on the speaker, you can talk to each other through
the microphone hole, aer call ended, it will connue to play music.
3. Long press the pause buon on the speaker to reject an incoming call.
4. When you connect your phone, press twice in rapid pause buon to call back the last call by
telephone.
Hold the power buon for 6 seconds to automacally reset the speaker and turn it off .
The speaker will automacally turn off in 10 minutes when Bluetooth is not connected and no music is playing.
HANDS-FREE FUNCTIONALITY
RESET FUNCTIONALITY
AUTOMATICALLY TURN OFF FUNCTIONALITY
THE PAUSE BUTTON’S FUNCTIONALITY
Short Press: 1) Music playback status: play, pause funcon.
2) When there is an incoming call: answer the call.
3) When you’re receiving the call: hang up the phone call.
Long Press: 1) When you’re calling: Press 2 seconds to reject the call.
2) Press 2 seconds to enter TWS connecon, once connected,
press 2 seconds to disconnect TWS connecon.
Double press: When it’s connected via Bluetooth to your phone: to call back the last call.
CHANGE VOLUME AND SONG
When listening to music
Increase volume: Short press on the “+” buon.
Decrease volume: Short press on the “- “ buon.
Previous song: Long press on the “-” buon.
Next song: Long press on the “+” buon.
360.0 mm
TECHNICAL PARAMTERS
PACKAGE INCLUDING
• 1pcs* Q1 wireless speaker • 1pcs* Product manual • 1pcs* Micro USB cable
• Model: Q1
• Speaker: Ø43mm 4Ω 3W*1
• Charging me: 3 hours
• Input: 5.0V 1.0A
• Product Weight: 153g
• Bluetooth: V5.0
• Built-in rechargeable baery: Li-on, 3.7V, 800mAh
• Playing me: 4 hours
• Product Size: 86*86*49mm
• Range: Up to 10m
• Waterproof level:IPX4
NOTES BEFORE USE
This product is designed with full aenon for safety performance. To ensure safe operaon, please follow
the following rules:
1. Place the speakers in a stable posion avoid fall and cause damage or personal injury.
2. Do not drop, disassemble, open, crush, bend, puncture, burn speaker.
FAULT AND MAINTENANCE
First fault: connecon failed.
Soluon:
(1) Please check whether the mulfuncon indicator light flashes blue. Please power on your speakers if
the light isn’t on. Please charge the speaker if the light is sll not on.
(2) Please turn off the other Bluetooth devices, if there are many Bluetooth devices surrounding. This may
result in search difficules.
(3) Restart wireless speaker on devices for Bluetooth search funcon.
Second problem: The music player appears sound breaks.
Soluon:
(1) View the distance between the player and the speaker has not been exceeded offecve Bluetooth
connecon distance 8-12meters.
(2) Ensure there is not any obstacle between the play device and speakers.
(3) Check the playback device or whether the speaker is in a low power state.
EXPLANATION
FCC STATEMENT:
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operaon.
3. Do not close to any heat source (such as radiators, heang equipment, stoves, or other heat-generang
equipment) where the use of speakers.
4. Please send professional maintenance staff to repair for any reason damage.
5. Before wiping with a dry cloth to clean the speakers, set the power switch to the off posion and unplug
the power cord from the power outlet.
6. Health consideraons, please adjust the sound to a suitable level.
WARNING:
NOTE
Changes or modificaons not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment complies with FCC radiaon exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator &
your body.
FCC Radiaon Exposure Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful
interference in a residenal installaon. This equipment generates uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instrucons, may cause harmful interference
to radio communicaons.
However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment
does cause harmful interference to radio or television recepon, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Adjust the volume.
Make sure that your Bluetooth device is within range.
Ensure there is no obstacles in the way that can block/disturb the signal.
Check via the device’s Bluetooth connecon if the speaker is connected with the device.
There is no sound?
Move the device closer to the speaker or try removing obstacles between them.
There is poor sound quality?
Disconnect other connected devices and then try again.
You can force a disconnecon by moving out of Bluetooth range (10 m).
Cannot connect the device with the speaker?
In order to avoid harming the product performance, please do charge your device each 3 months at least.
Recharge your speaker.
Reset your speaker. hold the power buon for 6 seconds to automacally reset the speaker and turn it off .
TROUBLESHOOTING
The speaker does not turn on ?
The speaker does not turn off or does not respond ?
TWS CONNECTION
1: Turn on both speakers
2: Press and hold the Play/Pause-button on one of the speakers for about 2 seconds until you hear a
“beep”sound. The default is the primary speaker that you operated the Play/Pause-button of this
spaker for pairing initially.
3: Release play/Pause button. It can take a few more seconds before speakers connect to each other.
Check the indicator lights to distinguish L/R channel: The blue light on one speaker is flashing blue for
every 3 seconds that should be the left channel(the primary speaker); the blue light on the other speaker
is solid blue that should be the right channel
4: Go into the Bluetooth menu on your smartphone and pair the speakers with your phone by selecting the
speaker model number. (it will only display 1 number which is both combined in to one)
TWS DISCONNECTION
1. Press and hold the Play/Pause-buon on one of the speakers for about 2 seconds unl you hear
a “beep”sound
9.
10.
3.
PLAY MUSIC USING MICRO SD CARD
Connect a micro SD card and power on the speaker.
Turn on the speaker, the bluetooth indicator flashing blue, on your device search for Bluetooth devices.
Select the speaker from the list. It will give an indicaon sound when the connecon is successful.
the bluetooth indicator solid blue. Only one Bluetooth device can be connected at the same me.
If you want to connect another device to the speaker, then first disconnect the current one.
User Manual
OZ-Q1
1. the symbol indicates: The product is only suitable for the safe non-tropical climates.
2. Note: Please use the same type or equivalent type of baery to replace if the baery is scrapped.
Otherwise maybe explosion occurs.
3. The lithium baery may not be exposed such as fire or excessive heat.