User Manual

Welcome Guide
WA918 Door Bell
Instructions
Install Batteries
Insert the 4x AA batteries (not included) into the battey compartment.
Music Selection
Press “music switch” button to change the melody.
Mode Selection
There are 3 operating modes for VOXON WA918: LED + ring tone, LED, ring tone.
Simply press “Setup” button to change the mode.
Volume Adjustment
There are 4 levels of volume for VOXON WA918:
Press “Volume +” button to increase the volume.
Press “Volume -” button to decrease the volume.
Method of Installation
1. Receiver Installation:
You can stand the receiver in an upright position wherever you like or use screws to
fix the receiver in a desired location on a wall.
2. Transmitter Installation:
Method 2, Adhesive Tape:
Apply the double-sided adhesive tape on the back of transmitter case.
Remove the outer side of tape and attach the transmitter in a desired location on the
wall and press hard for 30 seconds.
Method 1, Screws:
There are screw locator knockouts in the back cover of transmitter - punch these out
to allow the screws to pass through and fix the transmitter in a desired location on the wall.
Maintenance
1. Ideally, use high quality alkaline batteries - they last longer and reduce the chance
of electrolyte leakage.
2. In order to protect the precision internal electronic components, it’s advisable that
unqualified users should not attempt to open the unit for maintenance.
3. Do not expose to direct sunlight or a humid environment - this will adversely affect the unit.
4. Correct use of the products helps to effectively extend the service life of the unit.
Pairing Method
(1) Choose the LED + ring tone mode.
(2) Press “Volume +” button 5 seconds until it chirps. The receiver is now in pairing mode.
Then press the transmitter button. When select melody sounds, the pairing is successful.
Note: The pairing method only takes place in the LED + ring tone mode.
Pairing Memory Clearance
Press the “Volume -” button 5 seconds until ringing (ding dong).
All pairing is now cleared and programme settings are returned to the default setting.
The unit returns to the first music chime and the transmitter is not paired with receiver.
Package Contents
1 x Transmitter (Remote controller, CR2032 Button-Battery Included)
1 x Receiver (Doorbell)
3 x Screws
3 x Screw-joint Coupling
1 x Double-Side Adhesive Tape
1 x User Manual
Product Features
• Stylish, sleek exterior design .
• Super-efficient eco power management mode reduces power consumption.
• Powerful transmitter provides an amazing 200 metres range for remote control.
• 58 optional music chimes. You can easily select and change chimes to suit
your taste or occasion.
• Four-level adjustable volume control.
• 3 Modes：LED + ring tone, LED, ring tone.
Product Specification
Transmitter Working Voltage: ≤ 3V
Transmitter Power Consumption: <10mW
Receiver Working Voltage: DC 4 x AA1.5V
Receiver Power Consumption: 0.4W
Sound Volume: 25-105dB
Working Frequency: 433MHZ±2MHZ
Transmitter Dimensions: 72 x 31 x 20mm
Receiver Dimensions: 113 x 68.5 x 37.5mm
1 2 3 4
Thank for purchasing this VOXON product!
Warranty
We warrant that products purchased from authorized distributors will meet the
applicable product specifications and be free from all defects in design, assembly,
materials and workmanship. Please contact retailers or visit our website
(www.voxonstore.com) for more information.
IMPORTANT SAFETY INSTRUCTIONS
CAREFULLY READ AND FOLLOW THESE INSTRUCTIONS.
1. SAVE THESE INSTRUCTIONS - This sheet contains
important safety and operating instructions.
2. Before using the product, read all instructions and caution
markings on the product, accessories and device when
using our product.
3. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
4. Children should be supervised to ensure that they do
not play with the appliance.
5. Keep the product away from fire or explosion may occur.
6. For indoor use only. Do not expose to rain, water, excess
moisture or snow.
Disclaimer
Every effort has been made to ensure that the information and procedures in this
guide are accurate and complete, no liability can be accepted for any errors or
omissions and we reserve the right to make any changes without further notice to any
products mentioned herein.
Limited 18-Month Warranty:
This warranty covers:
Shenzhen VOXON Technology Co., LTD. (Manufacturer: “VOXON”) warrants to the
original purchaser of this VOXON product that the product shall be free of defects in
design, assembly, material, or workmanship.
The period of cover:
VOXON warrants the VOXON product for 18 Months.
What will we do to correct problems?
VOXON will repair or replace, at its option, any defective product free of charge
(except for shipping charges for the product).
What is not covered by this warranty?
All above warranties are null and void if the VOXON product is not provided to
VOXON for inspection upon VOXON’s request at the sole expense of the purchaser,
or if VOXON determines that the VOXON product has been improperly installed,
altered in any way, or tampered with. The VOXON Product Warranty does not protect
against acts of God such as flood, earthquake, lightning, war, vandalism, theft,
normal-use wear and tear, erosion, depletion, obsolescence, abuse, damage due to
low voltage disturbances (i.e. brownouts or sags), non-authorized program, or system
equipment modification or alteration.
How to claim the warranty?
Please contact retailers or visit VOXON website www.voxonstore.com for more
information.
E-mail: [e-mail]
Website: www.voxonstore.com
5 6 7 8
7. Do not place product in or near inflammable, explosive
or hazardous objects.
8. Do not place in or near water, rain, excess moisture or
extreme heat.
9. Do not operate the product with a damaged cord or plug.
10. Do not operate product if it has been damaged in any
way.
11. Do not disassemble the product. Disassembly may
result in a risk of safety hazards.
12. Do not throw or shake the product.
13. To reduce the risk of electric shock, unplug the product
from the power supply when not in use or switch off the
power supply.
Product Illustration
1. Use a small flat blade screwdriver
to remove the transmitter cover.
3. Close the rear cover.
2. Use two screws for fixing or use
double-sided adhesive tape on the back.
4. When the battery runs out, use a small flat blade
screwdriver to push battery out, then replace with a new one.
6
5
7
8
5. Volume Adjustment Button +
6. Volume Adjustment Button -
7. Music Switch Button
8. Setup Switch Button 9. Insert the 4x AA batteries into the battey compartment before use.