Remote Spray Trainer Operation Guide
Remote Spray Trainer Operation Guide Thank you for choosing SP32 Remote Spray Trainer. Our mission is to offer the best electronic training solutions. We want to ensure your dog’s safety by providing you with the tools and techniques to successfully train your pet. Please feel free to contact us if you have any problems and we will resolve them immediately. Please read the complete operation guide carefully before starting to train your dog including the FAQ.
CAUTION Please read and follow the instructions in the manual. Proper fit of the collar under the dog’s neck is important. A collar worn for too long or made too tight on the pet’s neck may cause skin damage. Ranging from redness to pressure ulcers; this condition is commonly known as bed sores. 1. Avoid leaving the collar on the dog for more than 8 hours out of every 24 hours and try to reposition the collar on your dog’s neck every 1 to 2 hours if possible. 2.
Do not expose the device to freezing temperatures -32°F or 0°C or to conditions warmer than 113°F or 45°C. Do not leave the unit in direct sunlight. Never leave the unit in a car where the device can heat up to high temperatures 113°For 45°C. AEROSOLS: 1.Keep out of reach of children. 2.Contents of the refill can and the spray collar are under pressure. 3. Use only in a well ventilated area. Use only as directed. 4. May explode if heated, do not heat. Do not expose to temperatures over 113°F or 45°C. 5.
Do not smoke while refilling. 9. Do not puncture. Contact of liquid propellant with skin may cause frostbite. 10. Do not ingest. In case of accident, seek medical care. If swallowed, call a poison control center immediately. The Remote Spray Trainer is not a toy. Keep it away from the reach of children. Use it only for its pet training purpose. These steps will help keep your pet safe and comfortable. Millions of pets are comfortable while they wear spray collar.
Table of Contents Components…………………………………………....6 How the system works…………………………............6 Main Features………………………………………….7 Transmitter…………………………………………….9 Receive Collar………………………………………...11 Charging……………………………...……………….12 Match a Receive Collar………..………….…………...14 Training Guide……………………………………..…..14 General Training Tips.……………………………........16 How Dogs Learn……………………..……………..….18 Frequently Asked Questions…………………………...
Components How the System Works The SP32 Remote spray collar has been proven safe, comfortable, and effective for all pets over 6 months old. This system assists you in controlling your pet without a leash in a long distance range.
collar and emitting safe spray or warning beep or vibration . Using the remote trainer consistently and correctly, many misbehavior that your pet exhibits can be corrected or any basic obedience commands can be taught. Important: The actual distance of remote trainer depends on the way you hold the remote transmitter, the range may vary. Hold the remote transmitter in a horizontal position away from your body to achieve optimum range.
- Long and Short spray. - One vibration. - One warning beep. - Rechargeable 3.7V Li-ion battery for receiver and remote control -Strong TPU Collar Strap. - LED low power indication for receive collar. Red light will flash 1 time per second when battery level is low. - Comes with warranty.
Transmitter Led Display Up Button Spray Button Down Button Vibration Button Power Button Beep Button USB Cover Led Display: Display the 3 training mode: Spray ,Vibration and Warning Beep; Battery level and spray level -9-
Spray button: Press 1 time - receive collar emit one spray . Vibration button: Press 1 time - receive collar emit one vibration. Beep button: Press 1 time - receive collar emit one warning beep. USB Cover: To charge the Transmitter , Open USB cover , connect The transmitter and 5V DC power supply via Type-C USB cable Up button: Adjust spray level to long spray , press button 1 time ,the LED display “H” Down button: Adjust spray level to short spray , press button 1 time ,the LED display “L”.
Receive Collar USB Cover Led Light On/off Button Spray Nozzle Refill Port On/Off Button: Press and hold on 1 second to turn the collar on. Two confirming tones will sound and then the green LED light will flash 1 time per 5 seconds. Press and hold on 1 second to turn the collar off. One long tone will sound and the green LED light will stop flashing and turn off.
Function and Response Table Function LED Light Response Unit is on Green light flash 1 time per 5 seconds Low battery Red light flash 1 time per second Charging Red light is on Full charge Green light is on Charging The Receive collar and Transmitter can be charged rapidly in about 2 hours. Though 3-4hours is better for the battery life. They can be charged by connecting USB cable and 5V DC power supply, such as cell phone adapter, notebook, or computer.
higher than 0℃ when charging. The ideal charging temperature is between 10-45℃. Do not charge battery in hot areas. keep far away from fire. 1. Charge the receive collar 1) The red LED light is on when charging. 2)The green LED light is on and the red LED light is off when the receive collar is full charged. 3) The receiver’s red LED light will flash one time per second when the battery is low power. Please recharge the battery immediately. 2.
Match a Receive Collar Step 1: Press and hold “ON/OFF” button. After two “beep” sounds, release the button, the power of receiver is on. Step 2: Take out the transmitter. Press and hold on the button + button at the same time ,The Led display is “ P ” . Close to the receive collar 10-20CM , until hearing 5 “beep” sounds from the receiver then release . Note: You should match receive collar within 30 seconds after turning on the receive collar .
Make sure your dog is standing then place the collar strap on the middle of the dog’s neck. The receiver should be on the underside of his/her neck, with the Spray Nozzle towards the dog’s nose. The Receive Collar should fit snugly, yet loose enough to allow one finger to fit under the strap. Ensure a Proper Spray Pattern For the Receive Collar to perform properly, the nozzle must be positioned correctly and there must be a clear path from the Spray Nozzle to your dog’s snout. 1.
before each use. General Training Tips 1. Make training sessions short and positive (each session between 10-15 minutes.) 2. Train one dog at a time. 3. During the first initial training session, keep the dog in a familiar outdoor environment. 4. Use a long leash fastened to a non-metallic collar to help the dog's learning. 5. Be consistent. Give your dog a tone and/or spray with each misbehavior. 6. Teach the dog a command first before reinforcing the command with the remote transmitter. 7.
9. During training, look for all the positive changes in the dog's behavior and remember to reinforce them promptly with ample praise and reward. 10. If you notice one situation in which your dog misbehaves repeatedly, set up this situation as a training session. This will dramatically increase your chances of success. 11. If your dog has a timid reaction to the tone or spray (especially the first couple of times), do not be alarmed. Redirect his attention to a simple and appropriate behaviour (i.e.
exhibits such behaviour, contact a professional trainer. Aggression in dogs is the result of many factors - it may be a learned behaviour or it may be brought on as a result of fear. Another factor contributing to aggression in dogs is social dominance. Every dog is different. HOW DOGS LEARN Here are some basic guidelines that cover all your remote trainer work on obedience commands. Follow a step-by-step introduction process on each command.
Frequently Asked Questions Is the spray safe for my dog? Though the spray is unpleasant, it is harmless to your dog. Is the collar waterproof?NO,Don’t immerse in water . How old should my dog be before I use this device? It is recommended that your dog be 6 months old to use a training collar. Your dog should have learned the basic commands such as “sit” or “stay”. The collar is too long, is it ok to cut off the excess collar? Yes.
Testing for the 500 feet range is performed in perfect conditions. The range you get will vary according to terrain, weather, vegetation, as well as, transmission from other radio devices. For best results, make sure the collar has the light closest to the dogs nose and you hold the remote horizontally and away from your body. Does the spray need to hit my dog’s nose ? No. The spray is very fine and simply creates a mist in the region of the snout.
Troubleshooting Guide Problem#1: No spray or beep when buttons on transmitter are pressed. The receiver has not been activated. The receiver must be turned on otherwise it won’t work at all. The receiver has not been matched to your transmitter. Follow the instructions to match. Problem#2: The receiver light changes color to indicate low battery very quickly. The unit has been left turned on in between training session. Make sure the receiver is turned off after use. You are training in very cold weather.
Radio interference. Wait a short while then try again, or move to another area. Problem#4: The receiver can’t receive any signal or cannot work at all. Check the receiver on/off button, make sure the receiver is turned on. Check the transmitter, if it has a low battery, charge it first. The charger is broken, please try in your computer. Re-match the receive collar with the transmitter.