Quick Manual

ManualsBrandsSHENZHEN TOVISION TECHNOLOGIES ManualsElectronicsWireless base unit

M100-A/V Quick Manual

Product using environment: By using the strap to fix the camera on

the tree, or use camera mount to fix the camera on ground . When

the camera receive photos via LORA from slave cameras.It will upload

the photo according to the menu settings.

1. Working Mode

The camera has three working modes: on, setup, and off (as shown below).

ON mode ：

When you switch the camera into on mode, the camera will work according to

the menu settings.

SETUP mode：

When you switch the camera into setup mode, you can set the menu settings or

change the settings. (This mode is also special for manual upload photo test)

OFF mode：

When you switch the camera into off mode, the camera is powered off.(please

keep the camera in off mode when no operations needed)

Summary of content (5 pages)

PAGE 1
M100-A/V Quick Manual Product using environment: By using the strap to fix the camera on the tree, or use camera mount to fix the camera on ground . When the camera receive photos via LORA from slave cameras.It will upload the photo according to the menu settings. 1. Working Mode The camera has three working modes: on, setup, and off (as shown below). ON mode ： When you switch the camera into on mode, the camera will work according to the menu settings.
PAGE 2
.The main interface and button functions 2.1 Main interface As shown in the figure above, the camera enters the main interface after power on. 2.2 Buttons (As shown below) The camera has 6 buttons M button is for enter the menu setting ,press the menu button, the camera will enter the menu setting interface (as shown below) The OK button means YES when you choose the settings. The up, down, left, and right buttons can be used to select menu options.
PAGE 3
. Wireless function settings 3.1 4G Module Info (as shown below) When you press this option, it will shows the IMEI number and software version for 4G module. 3.2 4G Switch This option is for turn on/off the 4G module. But we also add three choices below for antenna testing, when you press down button. It will switch to antenna test. You can choose Both Antenna,Main antenna or diversity antenna. 3.3 4G Test Mode 4G Test Mode is for 4G upload testing.
PAGE 4
.Common settings. 4.1.Software version You can check software version by this option. 4.2 Format SD Card Enter the option, click the ok button, the camera will automatically format. 4.3 Set Clock Enter the option to set DATE. 4.4Default Enter the option and press OK.the camera will restore the default settings. Defaulting the setting after every FW update.
PAGE 5
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.