Quick Guide

ManualsBrandsSHENZHEN TOVISION TECHNOLOGIES ManualsCamera & Phototrail camera

Table Of Contents

Customizing the Camera Settings: (Cam)
- PIR and Time Lapse Options: (PIR)

L100 Quick guide

Connection with Lora base camera

1.Lora base interface.

When you turn on the Base unit, you will enter the interface above. Press M button to

enter the setup menu.

Matching Base unit with slave cameras

First. Press attached Slaves, Select the Slave IDs you want to use.

(For example, if you have 3 slave cameras need to be attached, then you can choose any

3 slave IDs out of S1-S9.

Second, turn on the slave camera. Choose the net tab to Module Info.

Base cam battery bar

Photo numbers of slave S1

saved on SD card.

Base cam 4G signal

Photo numbers received from S1

but not uploaded on portal

Base cam unique ID

Numbers of connected slave

cams

Currently，Base cam is connecting with

slave S1 and signal strength is 30，

greater number means better signal.

Currently communicating

with slave S1 in real time, the

font color will change to blue

The date & time of base unit,

slave cam will automatically

synchronize this time after

attached to base unit.

Summary of content (6 pages)

PAGE 1
L100 Quick guide Connection with Lora base camera 1.Lora base interface. Currently，Base cam is connecting with Base cam 4G signal slave S1 and signal strength is 30， greater number means better signal.
PAGE 2
Type the LoRa Main engine ID, it shows on base unit’s interface. Then choose slave camera’s ID on LoRa Camera ID. L100 interface Test Mode After you connect slave camera to base unit camera. You could use Test Mode to upload a photo to the base unit via 2.4G. You need to manually take a photo on the slave camera. Which you could just press right key button. And you will see sending progress on the screen.
PAGE 3
Customizing the Camera Settings: (Cam) Press the MENU button once to open the customization menus. You will see Camera Mode and Customize tabs on the screen. Press the ▼ button one time. Camera Mode should be highlighted in blue. Press OK. Under the Camera Mode tab, select whether you want Photo, Video or Picture+Video. Press OK to save. Press MENU to go back to the Camera Mode and Customize screen. Press the ▼ button one time until Customize is highlighted in blue. Press OK.
PAGE 4
Press the ▼ button to highlight the Trigger Mode option in blue. Under this setting you can choose PIR Trigger (Where the camera is triggered by heat or motion only), Time Lapse (Where you tell your camera to take pictures every 5 seconds up to 24 hours) or Both. Highlight your selection and press OK. Press the Menu button to go back to the previous screen. If you chose PIR, you will see PIR Sensitivity where you can choose low, normal or high settings. PIR Interval is the next customizable setting.
PAGE 5
PASSWORD: The default setting is OFF. Press the ▼ button to highlight the Password option in blue. Press OK. Scroll ▲ (up) to ON and press OK. Use the ▲ and ▼ buttons to choose your password and press OK to save your personalized password. Make sure you write down your password or store it in your phone so you don’t lose it. If you set this option to ON, you will not be able to access your camera without the password. This is a very important security feature.
PAGE 6
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.