TOPFLYtech TLP2-SFB Asset GPS Tracker User Manual 20200908
Thanks for your purchasing of the high-quality GPS tracker from TOPFLYtech. Please read this user manual carefully before installation and operation. Information in this manual is the property of TOPFLYtech. Changes to the specifications and features in this manual may be made by TOPFLYtech without prior notice. No part of this manual could be reproduced, copied, translated, transmitted, or published in any form or by any means without TOPFLYtech's prior written permission.
Contents 1. QUICK REFERENCE ..............................................................................................................................4 2. PRODUCT SPECIFICATIONS ..............................................................................................................5 3. STANDARD ACCESSORIES INTRODUCTION ................................................................................6 4. LED INDICATOR ...........................................................................
1. Quick Reference TLP2-SFB Attention i. TLP1-SFB obtains power through sunlight to extend the battery life. ii. Please make sure that the device is exposed to direct sunlight every day. This will be very useful to extend the battery life. If the device is not charged for more than three months, it may cause permanent damage to the internal battery. iii. Please give the device a fully charging before installation. iv. Only when the solar panel output voltage value is 0.
Disclaimer: Before using this device, customers should fully understand their usage scenarios and installation environment. TOPFLYtech will not be responsible for any lost caused by using the device in a wrong scenario or reporting rate. It is highly recommended that customers should contact with TOPFLYtech before deployment. We are glad to give suggestions. Intelligent Power Management To extend the battery life, we designed an intelligent power management algorithm.
Sensitivity Cold start: -149 dBm Tracking: -163 dBm Position Accuracy in open sky (CEP-50) < 2m Standalone TTFF Cold start: < 29s Warm start: < 27s Hot start: < 1s Interfaces Charging and Data Transmission 4 Pin port with magnet Network, GNSS Antenna Internal only Indicator LED Network, GNSS and Battery FOTA Yes Physical Power Switch 1 Light Sensor 1 back light sensor Temperature Sensor 1 temperature sensor BLE 5.
4. LED indicator Note: Indicator lights will go out automatically after the tracker turns on for 70 seconds without connecting to the external power via USB cable. 5. Installation Guide 5.1 SIM card pre-installation note 5.1.1 SIM card data service should be enabled. 5.1.2 If SIM card is locked via PIN, please unlock it first. 5.1.3 Ensure there is sufficient balance in the SIM card. 5.2 SIM card installation and tracker power switch 5.2.1 Open the tracker SIM card slot cover with the screwdriver.
5.3 Installation 5.3.1 Away from emission source such as all kinds of sensors, burglar alarm and other communication devices. 6. Tracker Operation 6.1 Physical power on or off 6.1.1 Turn the power switch to on or off position. 6.1.2 Physical power off is recommended when the tracker is stored in the warehouse. 6.2 Motion operations Hold the tracker and keep the indicator LED side towards the sky. Use normal speed to turn it over 180°(the solar panel side towards the sky) then recover.
Alarm Code Description Alarm Code Description 1 Device removal (VS alarm 21) 16 Start moving (VS alarm 17) 5 Start falling (VS alarm 24) 17 Stop moving 6 Low battery (Vs alarm 7) 18 Idle start (VS alarm 19) 7 Battery recover 19 Idle stop 8 Device high temperature (VS alarm 25) 21 Device mounted 9 Vibration start (VS alarm 26) 24 Stop falling 10 Collision (VS alarm 27) 25 Device high temperature disappear 11 Tilt start (VS alarm 28) 26 Vibration stop 12 USB cable connecte
(underground, building, etc) 8.4 Position Drift In an area with poor GNSS signal (like the areas with lots of high buildings), position drift may happen. When the device moves to open area, the drift will no longer exist. 8.5 No Command Reply 9. 8.5.1 Check the command format. Make sure it’s correct. 8.5.2 The device may be in network blind area. 8.5.3 Ensure the SIM card is properly inserted. Warranty and Stock The device standard warranty period is 12 months starting from the date of purchasing.
APN Name: Range: APN of service provider Length Limit: 1~32 Username: Range: Letters and Numerals Length Limit: 0~32 Password: Range: Letters and Numerals Length Limit: 0~32 Note: 1) Tracker will return “SET APN OK” when received this command. 2) If there is no Username and Password, the SMS setting is: APN,Current PIN,APN Name,,# 3) If there is no APN PIN, the SMS setting is: APN,Current PIN,APN Name,Username,# 10.
Range Limit: 0, 3~ 4294967295 second Default: 240 Angle Compensation: Range: Positive Integer Range Limit: 0~90 degrees Default: 30 degrees Distance Compensation: Range: Positive Integer Range Limit: 0 ~ 65535 meters Default: 0 meters Note: Tracker will return “SET TIMER OK” when received this command. 10.
Length Limit: 0~40 Default: Note: 1) Tracker will return “SET MANAGERA OK” when received this command. 2) The max manager number is 4 10.7 Delete Manager Phone Number MANAGERD,Current PIN,Manager Code# Manager Code: Range: Positive Integer Range limit: 1~4 Note: Tracker will return “SET MANAGERD OK” when received this command. 10.8 List Manager Phone Number MANAGERL,Current PIN# Note: 1) Tracker will return “SET MANAGERL OK” when received this command. 2) All the manager phone numbers will be listed.
TSDT1-B BLE 5.0 Wireless Door and Temperature Sensor TSR1-B BLE 5.0 Wireless Relay TA39 Magnet Set (4 units) FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator& your body. Shenzhen TOPFLYtech Co., Limited.