Installation Instructions

ManualsBrandsShenzhen Topband ManualsElectronicsWireless Charger

69mm

73mm

正面

1. Charging: Mobile phone on , the LED long light blue menas

charging starts, when blue change to red means full charged.

2. Standby: LED light off.

3. FOD/Abnormal: red LED flash .

Remark:

1. Put on the phone, the fan starts automatically.

2. Take down the phone and the fan stops automatically.

1. Please use a 9V/2A, 5V/2A, 12V/1.5A adapter

and high quality cable to ensure charging effect.

fabic

Input: DC 5V/2A, 9V/2A, 12V/1.5A

Output：5W/7.5W/10W/15W

Efficiency:≥73%

Transmission Distance: ＜8mm

Conversion Efficiency: ≥72%

Standard: QI wireless charging standard

Size:Ø110x20mm

LED Indicator

Model No.: WPA03

FCC WARNING

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired

operation.

Any changes or modifications not expressly approved

by the party responsible for compliance

could void the user's authority to operate the

equipment.

NOTE: This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or

television reception,

which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by

one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and

receiver.

-- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician

for help.

The equipment complies with FCC radiation exposure limits

set forth for an uncontrolled environment. During the

operation of device a distance of 15 cm surrounding the

device and 20 cm above the top surface of the device must

be respected.

Summary of content (1 pages)

PAGE 1
正面 73mm 1. Please use a 9V/2A, 5V/2A, 12V/1.5A adapter and high quality cable to ensure charging effect. Input: DC 5V/2A, 9V/2A, 12V/1.5A Output：5W/7.5W/10W/15W Efficiency:≥73% Transmission Distance: ＜8mm Conversion Efficiency: ≥72% Standard: QI wireless charging standard Size:Ø110x20mm 69mm Model No.: WPA03 LED Indicator 1. Charging: Mobile phone on , the LED long light blue menas charging starts, when blue change to red means full charged. 2. Standby: LED light off. 3. FOD/Abnormal: red LED flash .