Safety Information

ManualsBrandsShenzhen Tinno Mobile Technology ManualsCell PhonesSmart phone

1 2

Product safety information

Pictograms and graphic symbols

Read the Product safety information section of

this document before using the device to make

sure to follow the same headline as on page 2.

Failure to comply with safety warnings can result

in serious injury.

Do not use while refuelling or near gas or

flammable liquids.

Do not use while driving.

This device may produce a bright or flashing light.

For body-worn operation maintain a separation

of 5 mm.

Do not dispose of this device or its battery in a fire.

This device is not intended for use by young

children. If you allow a child to use it ensure the

child is strictly supervised. This device contains

small parts which are a choking hazard.

Avoid contact with magnetic media.

This device may produce a loud sound.

Avoid extreme temperatures.

Keep away from pacemakers and other personal

medical devices.

Avoid contact with liquid, keep dry.

Switch off when instructed in hospitals and

medical facilities.

Do not try to disassemble.

Switch off when instructed in aircraft and airports.

Do not rely on this device for emergency

communications.

Switch off in explosive environments.

Only use approved accessories.

Do not use this device whilst walking across a road

or cycling.

Product safety information

RF exposure

General statement on RF energy

Your phone contains a transmitter and a receiver. When

it is ON, it receives and transmits RF energy. When you

communicate with your phone, the system handling your

call controls the power level at which your phone transmits.

FCC RF Exposure Information

This device meets the government’s requirements for

exposure to radio waves.

This device is designed and manufactured not to exceed the

emission limits for exposure to radio frequency (RF) energy

set by the Federal Communications Commission of the U.S.

Government.

The SAR limit of USA (FCC) is 1.6 W/kg averaged over one

gram of tissue. Device types VFD 630 (FCC ID: XD6VFD630)

has also been tested against this SAR limit.

The highest SAR value reported under this standard

during product certification for use at the ear is 0.76

W/kg and when properly worn on the body is 1.14 W/

kg. This device was tested for typical bodyworn operations

with the back of the handset kept 1.5cm from the body. To

maintain compliance with FCC RF exposure requirements,

use accessories that maintain a 1.5cm separation distance

between the user's body and the back of the handset. The

use of belt clips, holsters and similar accessories should

not contain metallic components in its assembly. The use

of accessories that do not satisfy these requirements may

not comply with FCC RF exposure requirements, and should

be avoided.

Summary of content (7 pages)

PAGE 1
Product safety information Pictograms and graphic symbols ead the Product safety information section of R this document before using the device to make sure to follow the same headline as on page 2. Failure to comply with safety warnings can result in serious injury. Do not use while refuelling or near gas or flammable liquids. Do not use while driving. This device may produce a bright or flashing light. For body-worn operation maintain a separation of 5 mm.
PAGE 2
Regulatory information This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 3
• Do not paint your phone or its accessories. Normal hand-held use position • Do not attempt to disassemble your phone or its accessories, only authorised personnel must do so. When placing or receiving a phone call, hold your phone to your ear, with the bottom towards your mouth or as you would hold a conventional fixed line phone. • Do not expose your phone or its accessories to extreme temperatures, minimum -10 and maximum +50 degrees Celsius.
PAGE 4
PROTECT YOUR HEARING T o prevent possible hearing damage, do not listen at high volume levels for long periods. Exercise caution when holding your device near your ear while the loudspeaker is in use. Do not touch your device with wet hands. Doing so may cause an electric shock. Do not touch the power cord with wet hands or disconnect the charger by pulling the cord. Doing so may result in electrocution.
PAGE 5
Pacemakers Explosive environments Pacemaker manufacturers recommend that a minimum separation of 15 cm be maintained between a mobile phone and a pacemaker to avoid potential interference with the pacemaker. To achieve this, use the phone on the opposite ear to your pacemaker and do not carry it in a breast pocket. Petrol stations and explosive atmospheres Hearing Aids People with hearing aids or other cochlear implants may experience interfering noises when using wireless devices or when one is nearby.
PAGE 6
In European Union countries: These collection points are accessible free of charge. All products with this sign must be brought to these collection points. In non European Union jurisdictions: Items of equipment with this symbol are not to be thrown into ordinary bins if your jurisdiction or your region has suitable recycling and collection facilities; instead they are to be taken to collection points for them to be recycled. CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
PAGE 7
Address: 4/F.,H-3 Building, OCT Eastern lndustrial Park. NO.1 XiangShan East Road., Nan Shan District, Shenzhen, P.R.China. Manufacturer: Vodafone Procurement Company S.a.r.l. customer use; 4. I f this phone needs service or repair, it must be delivered at the user's cost. 5. T his warranty will be null and void in any of the following events: a) If the serial number or warranty seal on the equipment has been defaced or removed.