How-To Guide

ManualsBrandsShenZhen Targetever Technology ManualsElectronicsWireless Controller for SWitch

DG011 Manual

Switch Bluetooth Gamepad

Product Features:

1.Material:New ABS material

2.Buttons:Home Button/Capture Button/-Button/+Button/A Button/B Button/X

Button/Y Button//ZL Button/L Button / ZR Button/ R Button/D-pad control / L3 Button

/R3 Button

3.Connect Method:Connect Via Bluetooth

4.Vibration:With double motors inside, support vibration on switch console.

5.Sensor: With six axis inside to make games feel in reality

How to Connect:

Press “Y”+”Home” Buttons simultaneously 1s to step into Bluetooth searching mode.

The four LEDS flashing and will be keep light when it connected.

PS:

Reconnect Mode:Press Home button for 1s to wake up the controller to reconnect.

If can`t reconnect in 10s will keep sleep mode.

Console paring interface

1.How to set into the console pairing interface:

Summary of content (6 pages)

PAGE 1
DG011 Manual Switch Bluetooth Gamepad Product Features: 1.Material:New ABS material 2.Buttons:Home Button/Capture Button/-Button/+Button/A Button/B Button/X Button/Y Button//ZL Button/L Button / ZR Button/ R Button/D-pad control / L3 Button /R3 Button 3.Connect Method:Connect Via Bluetooth 4.Vibration:With double motors inside, support vibration on switch console. 5.
PAGE 2
B C 2.3D joystick adjustment: A.
PAGE 3
B. Press A button step into the below interface and choose calibrate control sticks C. Press A step into below interface （ from right joystick to Left joystick) D.
PAGE 4
E. And then press X button step in to calibrate interface,and do actions based on the remind Android Mode: Press A and HOME button, LED2 and LED3 flashes. When LED2 and LED3 keep lighting, the gamepad connected. PC Mode: Connect gamepad into PC via charging cable. The gamepad will default into Xinput, LED1 and LED4 keep lighting. Keep pressing “+” and “-” for 3s to switch modes between Xinput and Dinput. When it is Dinput, LED2 and LED3 keeps lighting. Turbo/Clear Function: 1.
PAGE 5
Sleep Mode: 1.The console screen power off, the controller goes to sleep mode. 2.When connected, the controller without any action in 5minutes then step into sleep mode. Reconnect Mode: Based on the console not in sleep mode, if the controller under sleep mode, press Home button for 1s to wake up the controller, And it will searched and reconnect for the already connected console. If couldn`t reconnect in 10s the controller will step to sleep mode. PS: No other function buttons can wake up the controller.
PAGE 6
FCC Caution： This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.