Wiring Diagram

LED Controllers
09.283K4.04270
Important: Read All Instructions Prior to Installation
Function introduction
Product Data
All on
Zone 1:Click to turn on,
Press and hold down to increase
light intensity
Zone 2:Click to turn on,
Press and hold down to increase
light intensity
Zone 3:Click to turn on,
Press and hold down to increase
light intensity
Zone 4:Click to turn on,
Press and hold down to increase
light intensity
Front side
All off
Zone 1:Click to turn off,
Press and hold down to decrease
light intensity
Zone 2:Click to turn off,
Press and hold down to decrease
light intensity
Zone 3:Click to turn off,
Press and hold down to decrease
light intensity
Zone 4:Click to turn off,
Press and hold down to decrease
light intensity
• Control 4 zones of receivers separately
• Single color controller
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Safety & Warnings
• This device contains a button lithium battery that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Pair with RF receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
RF LED Receiver
Learning Key
Step 2:Click the “Learning Key” button on RF receiver or re-power on the receiver
three times continuously to set it into pairing status
Step 3:Choose one zone and click or of the zone(e.g. zone 4),
LED lights connected with the RF receiver flicker once means the receiver is
paired with zone 4 successfully.
Note:Before the first use, please remove the protective film on the battery.
Back side
After pairing, click or hold or of 1/2/3/4 to control each zone separately
Note: one receiver can be paired with max 8 remote controls.
Output RF signal
Operation Frequency
869.5MHz
Power Supply
3V(1xCR2032 battery)
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
136.3x38.9x10.7mm
SR-2833K4