Wiring Diagram

09.SB901K5M.04754
Note:Before the first use, please remove the protective film on the battery.
Function introduction
Important: Read All Instructions Prior to Installation
Back side
RF+Bluetooth US Size Single Color Remote Controller
Prog.
RF+Bluetooth LED Receiver
Output
RF+Bluetooth
Operation Frequency
2.4GHz
Operating temperature
0-40°C
Relative humidity
8% to 80%
Dimensions
66x32.5x8.9mm
Product Data
•
• DO NOT expose the device to moisture.
This device contains a button lithium battery that shall be stored and disposed properly.
Safety & Warnings
Power Supply
3V(1xCR2032 battery)
•
•
• Easy & quick pairing to the RF+Bluetooth receivers by simply pushing the buttons
• Mesh network for further control distance, receivers can transmit signal to each other
• Each remote can control numerous receivers
• Each receiver can be paired to max. 8 remote controls
• The controlled receiver status can be quickly synchronized to the smart APP
• Transmission range between every two neighbor devices up to 30m
• Bluetooth low power consumption technology, long battery life
RF+Bluetooth Single color wall mounted remote control
Enables to control 1 zone of receivers
Pair with RF+Bluetooth receiver
Step 3:
the receiver flicker once means the receiver is paired to the remote successfully.
Click any button of the remote(e.g. button ), LED lights connected with
Step 2: Prog. Key Reset
pairing status
Click the “ ” or “ ” button on RF+Bluetooth receiver to set it into
Note: one receiver can be paired with max 8 remote controls.
Step 1:
to the instruction of RF+Bluetooth receiver that you would like to pair with.
Do wiring the RF+Bluetooth receiver according to wiring diagram(please refer
Front side
Press and hold down to
increase light intensity
Press and hold down to
decrease light intensity
Press and hold down to
save color, click to
recall the saved
Click to turn on the light
Click to turn off the light
Bracket
magnet