Product Specs

Thank you very much for purchasing SEALIGHT. This is an In-car ambient light ambient

LED strip. With the APP that comes with the product, users are able to get colors they

want.

Restrictions and guidelines

1. Do not install the In-car ambient light ambient LED strip near water or in a corrosive

location.

2. Do not twist or trample the strip during installation.

3. Please place the wire safely fixed and hidden to prevent damage by tripping over the

line and dislodging the light strip.

Contents

LED strips

Control box

Remote Control

Manual

Clip

Velcro

Anti-vibration stickers

Product Specifications

Light color

RGB

Power supply mode

Car charger

Voltage

12V

Control mode

App + control box

Operating temperature

-25–50℃

Before installation

1. Open the box and check the contents.

2. Plug the car charger into the cigarette lighter and check whether the LED

strip is turned on.

Steps

1. Wipe the surface of the mounting position and make sure it is clean, dry and

smooth.

2. Place the control box in the armrest box and fix wires of the LED strips with a

clip as shown below.

PAGE 1
Thank you very much for purchasing SEALIGHT. This is an In-car ambient light ambient LED strip. With the APP that comes with the product, users are able to get colors they want. Restrictions and guidelines 1. Do not install the In-car ambient light ambient LED strip near water or in a corrosive location. 2. Do not twist or trample the strip during installation. 3. Please place the wire safely fixed and hidden to prevent damage by tripping over the line and dislodging the light strip.
PAGE 2
3. Remove the red protection film of the LED strips and paste the strip as shown in the figure below. 4. Firmly press the whole LED strip. Fix the strip with a cable tie. 5. Plug the car charger into the cigarette lighter and the LED strip will light up. It indicates the LED strip is powered on. Control via control box Buttons Functions Switch On/Off Mode Press the button to switch among 4 modes.
PAGE 3
Connect with the App 1. Turn on the Bluetooth on your phone and make sure the LED strip is powered on. 2. Turn on the App and tap the "+" icon. FAQs: 1. No light: Check whether the light is properly wired and the interface is tightly inserted. 2. Bluetooth connection fails: Make sure that the Bluetooth on your phone is on. 3. Compatibility fails: Please replace a new phone or upgrade your phone system. 4. Search fails: Keep the product within 2m to your phone. 5.