User's Manual

Table Of Contents

Model:SM612AG

The RF2.4GHz optical mouse use one AA alkaline batteries.

Nano receiver

* This mouse is equipped with Traveling-Power-Save function.

When you are traveling with this mouse, the LED of the mouse will be switched off

automatically for the purpose of power-save, but the pre-condition is that the

receiver is disconnected with your notebook or PC.

* when your mouse no any clik or scroll or moving, the mouse will come to sleep

state for the economize after about 30 minutes, for the wake up, you can click any

button for this

Your optical 6 button mouse is provide 800&1200&1600 dpi switch.

1:when you want use the mouse ,you can take out the receiver to computer by the

list step;

2:when you need stop the work or to travel, you can store the receiver on the mouse

for the moving by the list step.

DPI Switch

1.Connect the USB plug nano to USB port of the computer

When you find this set doesn't work, you can make the mouse in working condition

by restoring the mouse back to factory default settings.

1: check the battery volume is normal; if the battery is used out,

new batteries.

if the battery volume is normal, please take out the battery and insert

again the battery into the mouse.

2:insert the nano receiver onto the USB port of PC or notebook,make sure that

the mouse is close to the receiver for auto-matching.

please replace

PAGE 1
The RF2.4GHz optical mouse use one AA alkaline batteries. Your optical 6 button mouse is provide 800&1200&1600 dpi switch. DPI Switch 1:when you want use the mouse ,you can take out the receiver to computer by the list step; 2:when you need stop the work or to travel, you can store the receiver on the mouse for the moving by the list step. Nano receiver 1.Connect the USB plug nano to USB port of the computer * This mouse is equipped with Traveling-Power-Save function.
PAGE 2
FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.