What bands and wireless providers are served with this booster? Frequency Bands: Cellular 850 (Band5)/PCS-1900(Band2) Cellular PCS Uplink 824-849 1850-1910 Downlink 869-894 1930-1990 Frequency (MHz) SolidRF SR42152001 Delivers up to 10 dB of gain and supports CDMA, GSM, EVDO, LTE, HSPA+ and WCDMA technologies.
a cell tower but still experience failure data connection. This often occurs in buildings in which stucco, concrete or metal walls may block the signal. Easily solve these problems by installing a SolidRF booster. Overview of installation 1. Select installation location away from direct sunlight, heat, water and proper ventilation. 2. Run the Outside Antenna cable to the Signal Booster and attach it to the connector labeled “Outside” on the Signal Booster.
Booster function Figure 1 OUTSIDE:Outside port is connected to outdoor cable, outdoor antenna, lighting arrester. INSIDE: Inside port is connected to the indoor cable. LED display: it shows the signal strength (see table 1) of selected band.
1 ≥ -85dBm 2 ≥ -80dBm 3 ≥ -75dBm 4 ≥ -70dBm 5 ≥ -65dBm 6 ≥ -60dBm 7/8 ≥ -55dBm E Over heat / the antennas are NOT installed properly. F Self-Protection Table 1 MODE button: press it to choose LED display modes: 1. Turn off all display (except power light). 2. Display circularly the output signal strength of 800MHz, 1900MHz. 3. Display the output signal strength on the band selected by PRESS Band button.
Mounting & Connecting the Booster Outside antenna Outside cable Cellular modem RG174cable Power supply Booster 1、 Connection outside antenna: Attach the magnetic mount antenna to any metallic surface. The best location will be clear of obstacles. Make sure the area under the magnet is clean. Connect the magnetic antenna cable to the “OUTSIDE” connector of the booster and tighten it.
Warnings and Recommendations Warning: This is a consumer booster only. Warning: The antenna must not be co-located or operating in conjunction with any other antenna or booster. Warning: Unauthorized antennas, cables, and/or coupling devices are prohibited by FCC regulations. Please contact FCC for details: 1-888-CALL-FCC. Warning: RF safety, any antenna used with this device must be located at 20 cm (8 inches) away from persons or by bystanders. Warning: Use the power supply provided by SolidRF only.
Outside Antenna Outdoor Cable SR-01000200 SRG174-10N 10Feet 3dBi 4.2dB 3.5dBi Sucker antenna 8.6dB Description of network protection features: The SolidRF SR42152001 including safeguards to protect the cellular network from interference. Each Signal Booster is individually tested and factory set to ensure FCC compliance. 1. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware. 2.
This is a CONSUMER device you MUST REGISTER THIS DEVICE with your wireless provider and BEFURE USE , have your provider’s consent .Most wireless provider consent to the use of signal boosters .Some provider may not consent to the use of this device on their network .If you are unsure ,contact your provider. You MUST operate this device with approved antenna and cables as specified by the manufacturer .Antennas MUST be installed at least 20cm (8inches) from any person.
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
https://www.metropcs.