Pro 5 Bands Signal Booster www.SolidRFCanada.
BuildingForce 4G PRO Cellular Signal Booster User Manual Connect the world Features • • • • • • • • • Greatly reduces dropped calls, extends signal range, and increases data rates Allows multiple mobile devices to be used simultaneously Oscillation (or interference) detection and automatic shutdown with auto reset Overload protection circuit – protects cell towers from being overloaded Amplifies signals both to and from the cell tower Maximum 3 watts(EIRP) output power Works on all generations of 2G,3G a
1 Installation 2. Step by step installation Step 1: mount the outside antenna a. Choose right position • Find the strongest signal position in the possible install locations by read your cell phone signal bar; • 30cm away from any other metallic objects; • 100cm away from any windows; 1.How it work b. Mount the antenna pole; c.
2 Installation e. • • Set the outside antenna cable into the building Carefully arrange the cable along the building outside and make sure don’t fold it; Fix the cable at each corner; Step 3: arrange the booster a. Choose position • Be sure away from heat source; • In ventilate dry place, temperature range should -5~+50degree; b. Connect the outside antenna’s connector to the “outside” labeled port of the booster; c.
3 Installation Step 5: study GUI information a. “State” there are three statements for each link: red color for alarm, green color for normal and good condition, yello w for sleep mode; b. “Gain” is each bands’ current gain state in dB; c. “Pow” for each bands’ current output power in dBm; c. Pow a. state b. gain Step 6: setup each bands’ gain: press “Setup” then comes the next panel; a. “+” add attenuation to corresponding band; b. “-” reduce attenuation to corresponding band dB; c.
4 Cautions & Spec. Note4: Troubleshooting Note1: Some of the 12V DC lighter power sources • will not shut down when the vehicle is turned off. Please switch off the adapter when you leave the car, in case the battery of the vehicle is used up. Note2: Don’t cover the booster body with • anything, in case the power dissipation make the booster too high temperature. Booster will shut down when the temperature is too high itself.
Warnings and Recommendations Warning: This consumer booster is for Consumer use only. Warning: Unauthorized antennas, cables, and/or coupling devices are prohibited by FCC regulations. Please contact FCC for details: 1-888-CALL-FCC. Warning: Outside antenna orientation must be back side of inside antenna is to prevent the indoor antenna receiving the signal emitted by outside antenna. Otherwise it will cause self-oscillation of booster.
This is a CONSUMER device BEFURE USE ,you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent .Most wireless provider consent to the use of signal boosters .Some provider may not consent to the use of this device on their network .If you are unsure, contact your provider. You MUST operate this device with approved antenna and cables as specified by the manufacturer .Antennas MUST be installed at least 20cm (8inches) from any person.