What bands and wireless providers are served with this booster? Frequency Bands: LTE-707(Band12, 17)/LTE-781(Band13)/Cellular850 (Band5)/PCS-1900(Band2, 25)/AWS2100 (Band4). This equipment is a multiband signal amplifier which supports: Cellular 850 MHz, PCS 1900 MHz, AWS and 700 MHz for both AT&T and Verizon-4G networks as well as the Sprint 4G G-Block of 1900 MHz. SolidRF SR25652001 Delivers up to 70 dB of gain and supports CDMA, GSM, EVDO, LTE, HSPA+ and WCDMA technologies. How does it work? 1.
1. Location of the nearest cell tower – cell towers are situated to provide broad coverage; however, there are many areas in which signal strength may be reduced by topographic features or by local government restrictions on the height or placement of the towers themselves. Rural areas generally have fewer cell towers than urban regions. 2. Natural and man-made obstructions – signal strength can also be negatively affected by trees, hills, buildings, weather, and other obstructions.
Overview of installation 1. Select installation location away from direct sunlight, heat, water and proper ventilation. Do NOT install in a sealed enclosure. 2. Select a location on the roof of the building to install the Outside Antenna. Use a cell phone in test mode to find the strongest signal from the cell tower. Visit www.solidrftech.com to find test mode function for your particular cell phone. 3.
Booster function Figure 1 OUTSIDE:Outside port is connected to outdoor cable, outdoor antenna, lighting arrester. INSIDE: Port to the indoor cable, indoor antennas, coupler, power splitters. LED display: it shows the signal strength (see table 1) of selected band.
4 ≥-40dBm 5 ≥-30dBm 6 ≥-15dBm 7/8 E ≥0dBm Over heat / the antennas are NOT installed properly. F Self-Protection Table 1 MODE button: press it to choose LED display modes: 1. Turn off all display (except power light). 2. Display circularly the output signal strength of 700MHz, 800Mhz, 1900Mhz and 1700/2100MHz. 3. Display the output signal strength of the band selected by PRESS Band button.
connected to the Signal Booster. Turning the Outside Antenna about 45 degrees at a time, while the second person is watching the signal strength on the phone inside the building. This allows you to read the signal strength from the cell tower. It is preferable to have the phone in the test mode: The IPhones: Dial *3001#12345#*, The top left corner can be displayed as - 80dBm (strong or weak signal values will change). The android mobile phones: Dial *#*#4636#*#*,Click the phone information.
satellite TV service installed you may be able to follow the same route as the satellite TV cables that are already running from outside of your building to the inside. After routing the cable, we recommend sealing any areas where the cable passes into the building with cable bushings, silicone or other waterproof sealant to keep your installation from leaking.
roof or at the Inside Antenna as this will cause the oscillation protection circuitry to shut down the Signal Booster (see figure 3). Warning: Lightning protection is recommended for all installations (sold separately). Take extreme care to ensure that neither you nor the antenna comes near any electric power lines. Warning: Antenna installation is restricted to 10 meters or less height above ground, even if the antenna is installed indoor.
a way that they are able to pick up the best possible cell signal on the outside of the building and provide the best possible signal on the inside of the building. Mount the Outside Antenna as high as possible facing the cell tower in an area with the best possible signal coverage. Note: Never point the front of a Directional Antenna toward the Inside Antenna. See Figures 3 Installing the Inside Antenna(室内天线安装) Install inside antenna at least 1.5 meters high on the wall.
Warnings and Recommendations Warning: This consumer booster is for Home use only. Warning: Unauthorized antennas, cables, and/or coupling devices are prohibited by FCC regulations. Please contact FCC for details: 1-888-CALL-FCC. Warning: Outdoor antenna orientation must be back side of indoor antenna is to prevent the indoor antenna receiving the signal emitted by outside antenna. Otherwise it will cause self-oscillation of booster.
Antenna Kitting Information Component Prod No. Description Outside SR-31400100 Gain/Loss LTE-70 LTE- 800MH 1900M 1700MHz\2100 7dBi 8dBi 7dBi 10dBi 10dBi\10dBi Antenna Outside SR-31300100 3dBi 3dBi 3dBi 3.5dBi 3.5dBi\3.5dBi SRG58-30FN Cable 30Feet Outdoor SRLMR400-75FN Cable 75Feet Inside SRG58-15FN Cable 15Feet Inside SRLMR400-30NN 1.9dB Cable 30Feet Inside SR-21200100 4.5dB 4.5dB 4.9dB 7.6dB 7.2dB\8dB 4.2dB 4.2dB 4.4dB 6.1dB 5.8dB\6.5dB 2.35dB 2.4dB 2.56dB 3.
All equivalent antennas and cables are suitable for use with the SR25652001 booster. Default antenna and cable shipped with the booster Component Prod No. Gain/Loss Notes Description Outside LTE-7 LTE-7 800M 1900M 1700MHz\2100 07 81 Hz Hz MHz 3dBi 3dBi 3.5dBi 3.5dBi\3.5dBi SR-31300100 3dBi Antenna Omni-directio nal antenna Outdoor SRG58-30FN Cable 30Feet Inside Cable SRG58-15FN 4.5dB 4.5dB 2.35dB 2.4dB 4.9dB 7.6dB 7.2dB\8dB 2.56dB 3.9dB 3.7dB\ 4.1dB 7dBi 10dBi\10dBi 15
3. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. 4. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that band. 5. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute.
must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
www.T-Mobile.com/BoosterRegistration https://support.t-mobile.com/docs/DOC-9827 Verizon: http://www.verizonwireless.com/wcms/consumer/register-signal-booster.html AT&T: https://securec45.securewebsession.com/attsignalbooster.com/ U.S. Cellular: http://www.uscellular.com/uscellular/support/fcc-booster-registration.jsp Metro PCS https://www.metropcs.