User's Manual

ManualsBrandsShenZhen SolidRF Communications ManualsCell Phones3 band consumer cell phone booster for building only

Connect the world

www.SolidRFCanada.com 1

SOHO Tri Bands

Cellular Signal Booster

R3U01 User Manual

Features

• Works on AT&T 2G/3G/4G, Verizon 3G, T-Mobile 2G/3G/4G, Sprint 3G/4G, US Cellular 3G/4G, Metro PCS

3G/4G, All other Canadian Carriers 2G/3G, Major carriers using 850 MHz and 1900 MHz

• Allows multiple mobile devices to be used simultaneously

• Greatly reduces dropped calls, extends signal range, and increases data rates

• High integration semiconductor circuits design, internal integration inside antenna easily install

• Reduces radiation and extends battery life up to 2 hours additional talk time in weak signal areas

• Oscillation (or interference) detection and automatic shutdown

• Overload protection circuit – protects cell towers from being overloaded

• Power control logic ensures that maximum gain is within cellular standards

• Amplifies signal both to and from the cell tower

• Maximum 1 watts(EIRP) output power

Package Contents

Booster Inside Unit

Outside Antenna

&Booster Outside Unit

Power Adapter

Cable 30feet

Cable 15feet

Connector F-F to F-F

Technical Support: support@solidrf.ca

Inside Antenna

Summary of content (6 pages)

PAGE 1
SOHO Tri Bands Cellular Signal Booster R3U01 User Manual Connect the world Features • Works on AT&T 2G/3G/4G, Verizon 3G, T-Mobile 2G/3G/4G, Sprint 3G/4G, US Cellular 3G/4G, Metro PCS 3G/4G, All other Canadian Carriers 2G/3G, Major carriers using 850 MHz and 1900 MHz • Allows multiple mobile devices to be used simultaneously • Greatly reduces dropped calls, extends signal range, and increases data rates • High integration semiconductor circuits design, internal integration inside antenna easily install • R
PAGE 2
1 Installation 2. Step by step installation 1.
PAGE 3
2 Installation 1.3 Set the outside antenna cable into the building • Carefully arrange the cable along the building outside and make sure don’t fold it or roll up; • Fix the cable at each corner; Step 2: arrange the inside unit 2.1 Choose right position • 20cm away from any other metallic objects; 2.2 50cm away from any windows; • Be sure away from heat source; • In ventilate dry place, temperature range should 0~+50degree; 2.3 Connect the outside antenna’s connector to the “ANT2” port of the booster; 2.
PAGE 4
3 Installation Note1: about the outside antenna and outside booster unit The outside antenna and outside booster unit are integrated design, both them are waterproofed design. No matter rain or frog, they will work properly. But extreme temperature maybe causes problem to the booster unit, it will work perfectly from 20℃ to +55 ℃ temperature range. Too high or low temperature beyond that range will cause self-protection, the booster will lower down output power to avoid damage.
PAGE 5
Warnings and Recommendations Warning: This consumer booster is for Consumer use only. Warning: Unauthorized antennas, cables, and/or coupling devices are prohibited by FCC regulations. Please contact FCC for details: 1-888-CALL-FCC. Warning: Outside antenna orientation must be back side of inside antenna is to prevent the indoor antenna receiving the signal emitted by outside antenna. Otherwise it will cause self-oscillation of booster.
PAGE 6
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.